Drain plug location? - Cutlass Ciera Oldsmobile Cars & Trucks

If there is no drain plug on the transmission pan, you have to drop the pan to drain it.

Hi!!!

Drain plug is located on radiator bottom facing engine, driver side.

Note: Never open drain plug when radiator is hot, wait for it to cool down, remove radiator cap to release pressure then open drain plug.

Don't forget to rate this answer!!

It's located on the drivers side of the radiator opposite of the lower radiator hose. Note: you may be better off disconnecting the lower radiator hose, it's common for the drain plug to break or the O-rings to split causing more work to drain the radiator. That's why most tech's will drain the radiator from the lower radiator hose, less chance of breaking the radiator drain plug and most new cars now don't come with a drain plug to the radiator.

The drain plug is located on the bottom of the radiator.

Most drain plug ismake of inexpensive nylon/plastic and it may fall apart while you turn it.

The professional method is to loosen the lower radiator clamp and drop to lower radiator hose.

Drain the coolant onto a large drain pan and recycle the coolant.

the exact location is the bolt that sticks out of the bottom of oil pan

I don't know if there is a fill plug. I just use the level plug located on driver's side right above the inner CV joint of the half-shaft (axle) to fill it. A piece of flexible tubing connected to a funnel works well. The drain plug is fairly near the center of the bottom of the gearbox housing (behind the bell housing). The level plug has a 24mm, fairly flat, hex head, and the drain plug is a recessed plug with a 3/8" (?) square hole (for a socket handle).

Where oh where is the drain plug for the radiator on a 2005 Pacifica

Where i s oil drain plug?
GMC 2008 Sierra

The oil drain plug is located at the bottom of the engine under the car It should be a bolt directly in the oil pan that would be your oil drain plug.

actualy when the when you drain oil wnen you remove bolt there is washer mybe it is lost or not sealing after tighting drain bolt.
check first washer is in or its not tight put new washer.
or mybe thread is gun.means you cant tight drain plug.