I need help putting on 3 belts on a 1994 mercury villager gs 3.0

Question edited for clarity.
Question moved to model category.

I don't like the way this says 'is usually located'. It either does, or it doesn't!.

http://diyautorepairguides.blogspot.com/2014/01/how-to-replace-oil-pump-in-mercury.html

https://www.google.com/search?q=1994+Mercury+Villager+replace+oil+pump

Service and Repair Manuals

https://www.google.com/search?q=1994+Mercury+Villager+service+manual

..

Engine compartment main fuse panel 30 AMP fuse Fuse #4 scroll down and look at this diagram picture on this link. http://www.autogenius.info/mercury-villager-1st-generation-1993-1998-fuse-box-diagram/ caution, this fuse runs power seats, windows and sun roof as well.

Mercury Villager 1st Generation 1993 1998 fuse box diagram Auto Genius

keep adding fluid to full mark when trans is warm
villager quest yahoo group for more help

What marks did it get?

For the 1993 Mercury Villager 3.0L V6:

Firing Order:
1-2-3-4-5-6

Cylinders:
......(back)......
|...1....3....5...|
.......................
|...2....4....6...|
......(front)

Distributor:
..(back)
.....2
3........1
4........6
.....5
(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

drain coolant first,take off serpentine belt loose 6 bolts on water pump take off water pump clean well,put new gasket than install new pump

it's 1-2-3-4-5-6.

#1 is on the passenger side rear and #3 & #5 are also on the back.

#2 is in front on passenger side. #4 & #6 are across the front.

go here for expert villager help.

http://groups.yahoo.com/group/villagerquest/

Try disconnecting the battery for 2 hours. Then drive for 10 miles so the PCM can relearn. It may run rough for 10 miles.

If not ok, go to Villager website for expert team help free. Check files, ask questions

http://groups.yahoo.com/group/villagerquest/

Look under the hood, usually a belt diagram on the emissions sticker (look near the top of the radiator).

If you can turn the pump pulley by hand, likely it's OK... If so, change the belt. if not, you know what you need to do.