SOURCE: need to replace alternator in 2002 kia Rio 5
I just changed my brothers on a 2001 kia rio. You have to go from the bottom. There is a tensioning adjustment on the top you have to undo, as well as a bolt on bottom. It is hard to get it out because there is not a lot of room, i remember it hitting either a p/s line or the rack, and being frustrated. I used a floor jack and block of wood under the engine and jacked it up to reposition it. It gave me enough room to get it out. Remove the bottom bolt and disconnect the wiring from it and it should drop out with some effort. Getting it back in was harder. Once you get it back into position connect the wiring before you bolt it up all the way, put the lower bolt in, put the belt on, then back to the adjustment on top. Make sure everything is tight and you should be done.
SOURCE: 2003 kia rio- water pumps
If it is your first time having the timing belt changed, chances are the water pump is still in good enough shape to hold out until you are due for your next belt change. No sense throwing away money prematurely...
Testimonial: "thanks"
SOURCE: how many hours to replace a 2003 kia rio timing belt?
1.8 hours. dont forget to consider changing the water pump and tensioner.
SOURCE: kia rio 2003 timing belt snapped
take it in its alot of pissing around about the timing belt i wouldent recomend to do it yourself
SOURCE: knock sensor replacement
Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.
1,882 views
Usually answered in minutes!
×