How do you change the a/c compressor in a 1993 buick regal?

SOURCE: Buick Regal brakes

28-DEC-08
Sometimes (when changing the brake calipers on disk brakes, or changing wheel cylinders on drum brake systems) the mechanic will clamp a vise grip pliers on the rubber hose to prevent hydraulic fluid from dripping out.  This can break the internal fiber lining in the rubber hose.  Then the fluid flow can be blocked.  When you press the brake pedal, fluid may not flow to the wheel or wheels.  As you press harder, the fluid may suddenly flow through the line, causing the brakes to suddenly activate.  
Or an even more likely problem, your brakes drag (stay on) and get hot, because the fluid cannot flow back to the master cylinder when you release the brake pedal.  In other words, when you press the brake you force fluid through a partially blocked rubber hose.  But the return of the fluid (backwards through the rubber hose) is caused not by pressure, but just by equilibrium, a balancing act.  Well, if the line (rubber hose) is blocked, the fluid stays in the caliper or wheel cylinder, and the brake is still on, and the brake gets hot.  
Ken   Camas, Washington [email protected]

SOURCE: Car starts then stalls out...

could be to many thing to take chances with, but most commonly;fuel filter,gas line antifreeze or a crack in your air intake which would take your vacuum seal away, start with the least expensive and work from their. Worst case scenario pinched fuel line

SOURCE: Need diagram of 1993 Buick Regal Gran Sport suspension

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you or you can try www.schramauto.com or call them at 1-800-292-1032

SOURCE: I have a 1993 buick regal custom with 3.8 V6 fault codes

Idle position switch or sensor. I had 93 that would stall when i came to a stop. Cost me $43 but it was worth it. I don't know if this will fix it, but it sounds like it would.

SOURCE: signal bulb on 2003 buick regal

To change front turn signal –
open the hood; look in back of headlight; two white clips; pull straight up, and then whole headlight comes out including turn signal; it is all one unit; remove rubber cover, then you take bulb out of unit. Mechanism that bulb fits in will need to be turned clockwise (looking from the front) and pulled to get it out of the larger unit holding all lights. Be sure and put rubber cover back on before re-inserting the two white clips.