Ac is not cool - 2002 Mazda 626

A sensor could be the problem but look and make sure you have good electrical connections to the a/c compressor. sometimes they like to short out and cause major problems.

If the temp gauge shows normal, you would not expect the fan to be on much. It is controlled by the coolant temp sensor. If the fan will not come on when the car gets really hot, it is possible this sensor has failed.

It is normal for both AC and cooling fans to be on when you turn on AC to cool setting.

if engine at long stand still,the engine temperature will rise about 190 degrees the cooling fan suppose to automaticaly turn on when coolant temperature sensor get hot it cause its resistance decrease causing pcm to send power to coolant fan relays and cooling fans, when you turn on AC the cooling fans suppose to turn on to cool down AC CONDENSOR, IF NOT AC WONT WORK COOLING FAN COOLS DOWN REFRIGERANT SO IT CAN RECYCLE THROUGH THE SYSTEM AGAIN.your cooling is suppose to turn on when engine at a sit still if vechicle not moving as coolant temperature rises at a set point the cooling fans will turn on cool down engine.cooling fans dont turn on when you first cold stsrt vechicle unless you have AC SWITCH ON.if cooling fans dont turn on when vechicle at a long stand still or moving along slow traffic.if coolant temperature sensor been replaced and fuses and relays okay have dealership check see if pcm driver circuit working faulty pcm will cause cooling fans not to turn on.

check see if cooling fan running could have faulty cooling fan relay or fuse.if cooling fan dont run when ac on car will overheat.AC COMPRESSOR PUT LOAD ON ENGINE.

Hi Dennis, When the AC is selected an additional cooling fan should cut in to cool the additional requirements of the condenser radiator, mounted in front of the radiator cooling the engine. If the operation of the AC fan is intermittent the most probable cause is a defective control relay or a loose connection. The relays are easy to find, being in a housing usually marked on top of the outside. Regards John

Your ac system is most likely low on freon, or the cooling fan is not working.
When you turn on the ac the cooling fan should stay on.
If it stays on then you are low on freon.

HIGH PRESSURE CUTOFF SWITCH LOCATED ON AC COMPRESSOR DISCHARGE LINE LEADING TO THE CONDENSOR.THE HIGH PRESSURE CUTOFF SWITCH WILL CUT OFF THE AC COMPRESSOR IF SYSTEM PRESSURE RISES TO HIGH CAUSED BY RESTRICTION IN THE REFRIGERANT CIRCUIT OR OVERHEATED CONDENSOR.MAKE SURE COOLING FAN IS RUNNING WHEN THE AC SWITCH IS ON.THE COOLING FAN KEEP CONDENSOR COOL, IF COOLING FAN DONT RUN.YOUR AC WILL STOP BLOWING COLD AIR.HAVE THE REFRIGERANT SYSTEM CHECK OUT.MAKE SURE YOUR LOW SIDE PRESSURE IS 10 - 37 PSI. THE HIGH SIDE PRESSURE SHOULD BE 112 - 210 PSI. CHECK THE AC COMPRESSOR CLUTCH FUSE AND RELAY.

check your vacuum lines

Check the temperature control box.

u may have a cooling fan relay or cooling fan out,,,, the ac may be cutting out because it needs more freon it may not be over heating the low presure swtch is responsible for that