Check 15A fuses, #58 and #59,
- second possibility is stuck relay, check, swap place with same color relay [E32]
- ctrl solenoid valve resistance 1 and 2: about 7ohms at 20?°C (68?°F)
P0011 (Bank 1); P0021 (Bank 2)
- Intake valve timing control performance, There is a gap between angle of target and
phase-control angle degree.
Causes:
- Harness or connectors (Intake valve timing control solenoid valve circuit is open or shorted.)
- Intake valve timing control solenoid valve
- Crankshaft position sensor (POS)
- Camshaft position sensor (PHASE)
- Accumulation of debris to the signal pick-up portion of the camshaft
I'd add one possibility to the list: worn mech VTC parts if over
150k... possible if history contains lubrication problems. (Mech repair
will be costly; i'd try locking the system in place.)
All electronics checkups start from voltage checks, at batt, at ECU.
Then clean connectors, next test individual sensor inputs: see link p.14
below. Dig more/all info via 'Favorite Links', see link page below -
top left corner:
P0011 Electronic Throttle Control Actuator (bank 1) and P0021 is the same thing on bank 2.
To me this doesn't ring true unless the car is running extremely rough.
SOURCE: will you do damage to the engine with po011 and po021
this codes are errors. error are error need to be clear. it affects the engine performance.
P0011 = "A" camshaft position - timing over-advanced or system performance (bank 1)
P0021 = "A" camshaft position - timing over-advanced or system performance (bank 2)
Check
engine light comes on and off, these are indication that there is some
error code stored in your vehicles ECM. The engine module computer
needs to be scanned. These will give the code and as per the error code the
further problem can be detected and confirmed. The engine light
indicator blinks or remains steady on dash when engine computer
noticed any problem with any engine electrically operated components.
For
more help, I suggest you to refer the help links provided below. These will let
you know more about which areas to look, check, when there is engine light
coming up on dash panel.
---------
Click
the link below: -------
CHECK ENGINE LIGHT
http://alltypesofpartsreplacing.blogspot.com/2012/12/check-engine-lightengine-warning-light.html
---------------
Check Engine Light Reset Procedure?
http://whoisbyme.blogspot.in/2012/06/check-engine-light-reset-procedure.html
----------
These will help.
Thanks.
Check
engine light comes on and off, these are indication that there is some
error code stored in your vehicles ECM. The engine module computer
needs to be scanned. These will give the code and as per the error code the
further problem can be detected and confirmed. The engine light
indicator blinks or remains steady on dash when engine computer
noticed any problem with any engine electrically operated components.
For
more help, I suggest you to refer the help links provided below. These will let
you know more about which areas to look, check, when there is engine light
coming up on dash panel.
---------
Click
the link below: -------
http://whoisbyme.blogspot.in/2012/06/malfunction-indicator-light-on.html
---------
http://howtobyme.blogspot.in/2012/02/check-power-train-message-with-orange.html
-----------
http://whatisbyme.blogspot.in/2012/05/2007-toyota-highlander-hybrid-yellow.html
-----------
------------
http://whatisbyme.blogspot.in/2012/05/car-runs-fine-but-check-engine-light-is.html
----------
http://howtobyme.blogspot.in/2012/01/check-engine-light-with-codes-p2195-and.html
----------
http://schematicsdiagram.blogspot.com/2011/12/how-to-read-codes-from-check-engine.html
----------
http://schematicsdiagram.blogspot.com/2011/12/vehicle-smog-test-failed-due-to-no.html
http://schematicsdiagram.blogspot.in/2012/02/obd-code-is-cleared-but-check-engine.html
-------------
http://schematicsdiagram.blogspot.com/2011/12/car-jerks-while-going-uphill-and-check.html
-----------------
http://schematicsdiagram.blogspot.in/2012/02/toyota-camry-check-engine-light-flashes.html
-------
These
details will help.
Thanks.
http://schematicsdiagram.blogspot.com/2011/12/car-jerks-while-going-uphill-and-check.html
------------
Toyota Camry Check engine light flashes while
driving?
http://schematicsdiagram.blogspot.in/2012/02/toyota-camry-check-engine-light-flashes.html
----------1999 Toyota Tacoma: Check Engine Light
Read Code P0171?
http://whatisbyme.blogspot.in/2012/05/1999-toyota-tacoma-check-engine-light.html
--------
2007 Toyota Highlander Hybrid: Yellow Check
Engine Light ON dash?
http://whatisbyme.blogspot.in/2012/05/2007-toyota-highlander-hybrid-yellow.html
--------Check engine light with codes P2195 and
P2197?
http://howtobyme.blogspot.in/2012/01/check-engine-light-with-codes-p2195-and.html
---------Car Runs Fine But Check Engine light is ON?
http://whatisbyme.blogspot.in/2012/05/car-runs-fine-but-check-engine-light-is.html
----------After replacing throttle body the Check engine light starts
blinking?
http://technoanswers.blogspot.com/2012/01/after-replacing-throttle-body-check.html
---------OBD Code is cleared but check engine light
will not RESET?
http://schematicsdiagram.blogspot.in/2012/02/obd-code-is-cleared-but-check-engine.html
--------These will help.Thanks.
As per your problem,the check engine light comes on due to technical problems in your car.In this case i suggest you to click the link below :----Check Engine Light On car? http://schematicsdiagram.blogspot.com/2011/06/check-engine-light-on-car.html
------------Basically the computer needs to be scanned to retrieve the error codes stored in ECM.In this issue,i suggest you to click this link:----How to Read Codes from Check Engine Light? http://schematicsdiagram.blogspot.com/2011/12/how-to-read-codes-from-check-engine.html----------After scan procedure you will get P4 digit error codes.If suppose you get this error codes,then click the link below,to know more about error codes:----
Check engine light with codes P2195 and P2197?http://howtobyme.blogspot.in/2012/01/check-engine-light-with-codes-p2195-and.html
---------------There are many other reasons to for check engine light coming ON,i suggest you to click this link below and go through its troubleshooting procedure:---------Car jerks while going uphill and Check engine light is ON?http://schematicsdiagram.blogspot.com/2011/12/car-jerks-while-going-uphill-and-check.html
--------One more reason is as follows :----After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?
http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
---------
After replacing throttle body the Check engine light starts blinking?http://technoanswers.blogspot.com/2012/01/after-replacing-throttle-body-check.html
---------
This will help.Thanks.
http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html
---------
After replacing throttle body the Check engine
light starts blinking?
http://technoanswers.blogspot.com/2012/01/after-replacing-throttle-body-check.html
---------
This details will help you.Thanks.
1,888 views
Usually answered in minutes!
The "O" is a zero (0) after the "P" so the codes should read P0011, P0021 "P" stands for "Powertrain".
×