There's a loose connection somewhere causing it to stall. Best way to locate it is too leave the car running and open the hood and (carefully) start pulling slightly on the wiring harness in different locations, if you pull at a certain point and it stalls you know your in the right area.. Also has either a starter and or the engine ever been replaced??? Just curious if something like a ground or power feed wire may have been left loose.. Majority of the time when something like your prob. Occurs it's due to someone else not properly hooking up or tightening something.. Also you can try tapping on the under hood fuse block, (lightly) and see if that does anything. Seen a few fuse blocks go bad..
Look for a loose bulkhead connector, or something near the alternater. This ride should still be under warranty, so let the dealership figure it out!
356 views
Usually answered in minutes!
Cam acculater change valves,is under warranty,dealers have memo about it
×