REPLACE AIR FILTER.IF YOU HAVE 25000 MILES ON VECHICLE IT MIGHT NOT HELP PROBLEM MUCH FUEL TANK PRESSURE SENSOR COULD BE BAD.REPLACE AIR FILTER.IF YOU HAVE 25000 MILES ON VECHICLE IT MIGHT NOT HELP PROBLEM MUCH FUEL TANK PRESSURE SENSOR COULD BE BAD.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Your vehicle has no fuel pump relay . Has a fuel pump flow control module .
Fuel Pump Flow Control Module (FPCM)
The fuel pump flow control module (FPCM) is a serviceable GMLAN module. The FPCM receives the desired fuel pressure message from the engine control module (ECM) and controls the fuel pump located within the fuel tank to achieve the desired fuel pressure. The FPCM sends a PWM signal to the fuel pump, and pump speed is changed by varying the duty cycle of this signal.
Plus it has two fuel pumps !
The high pressure fuel pump (9) is a mechanical one cylinder design driven by an eccentric on the exhaust camshaft (1) of bank 2. High pressure fuel is regulated by the fuel rail pressure (FRP) regulator, which is a part of the high pressure fuel pump. The FRP regulator is a magnetic actuator which controls the inlet valve of the high pressure pump. The ECM provides battery voltage on the actuator high circuit and ground on the actuator low reference circuit. Both circuits are controlled by the ECM. When the ECM deactivates the FRP regulator, both circuits are disabled and the inlet valve is held open with spring pressure. When the ECM activates the FRP regulator, the low circuit driver connects the low reference circuit to ground and the high circuit driver pulse-width modulates (PWM) the high circuit. The ECM uses the camshaft and crankshaft position sensor inputs to synchronize the FRP regulator with the position of the eccentric on the camshaft. The ECM regulates fuel pressure by adjusting the portion of each pump stroke that provides fuel to the rail. The high pressure fuel pump also contains an integrated pressure relief valve.
Your best bet is have it towed to the dealer , you don't want to mess with the high pressure pump .
Pluse
A very common issue on the 3.6 liter V6 engine in the acadia is a leaky water pump. The pump starts leaking, causing a low coolant level, causing the engine to go into reduced engine power mode to keep the engine from overheating. This usually results in a very extensive cylinder head gasket repair job. You should have a local shop perform a cooling system leak check to find the leak for sure, and an engine block check to see if the overheat condition caused internal engine damage.
×