I have jeep liberty 2003 and it has gear 3and 4 incorrect ratio. the trany does not want to shift th higher gears- any advice what it could be?
IT COULD BE SOLENOID PACK OR THE GOVERNOR AND TRANSDUCER OR LOW FLUID OR THE MOST COMMON REPAIR SPEEDS SENSORS INPUT/OUTPUT. ALL OF THESE CONTROLS THE SHIFTING. START WITH THE SENSORS FIRST, VERY COMMON.
If there are no solenoid or speed sensor ( open or shorted) Codes, most likely the overdrive clutch hub is broken or the splines are stripped. O.D. clutch is on for 3rd and 4th gear.
I have a 2003 Jeep Liberty Renegade 4x4 I got codes P0731, P0732 and P0734 and car will still be in drive when put into neutral and car won move when put in reverse, But driving is weird Shifts fine speeding up but if you let go of the gas it immediately starts slowing down like your engaging the breaks when I am not. would like to figure this out, Hope I do not need a new transmission.
SOURCE: I have jeep liberty 2003 and it has gear 3and 4
faulty input speed sensor possible. sensors are fairly cheap and easy to install. no gaurentees because normally u will have more codes then just the 3-4 ratio with a faulty sensor but u may get lucky
6,285 views
Usually answered in minutes!
jeep grand cherokee shifts good but not in 4 th gear
jeep liberty transmission randomly downshifts when at approximately 50 kph
×