I want to temporailily disable my 2001 s10 from running so my adault child cant take my truck while imn at work i had read that their may b a theft deterrant if not what part can i take off or out EASILY and cn b put back easiliy im sick of bein used please help me

no you cant by pass or hotwire anti theft system

try pushing brake pedal, then insert key and flip it on and off 3 or 5 times then remove it. see if it will start.

If is factory you wont be able to unless you have a computer and a program to do that. If it wont go away just takeing the battery cable off, tehe dealer is going to have to do it

check your fuses for it

Your truck has an antitheft system called passlock. It runs thru you bcm. When this system fails, your truck will start for 1-5 seconds and then stall. The fuel enable is switched off, and injectors fail to squirt. This may be your problem and is a "bypassable" problem. This link explains.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

SOUND LIKE YOU FAULTLY WORN IGNITION KEY,FAULTY IMMOBILIZER READ COIL IN THE IGNITION SWITCH OR BCM FAULTY HAVE VECHICLE CHECK OUT AT DEALERSHIP AND FIX YOU CANT DISABLE THEFT SECURITY SYSTEM.

Read this link. The Anti theft security system may be your problem. Read thru the symptoms and compare to your situation

http://vatspasslockpasskeysecurityhelp.yolasite.com/

cant be disabled. I would have the dealer or a good repair shop diagnose and recommend repairs. Could be key or the lock cylinder/ sensor problem

You cant disable it, if you could, what good would a anti-theft system be? Keys and tumblers are a common problem, your dealer or a shop that has a Tech2 scanner can diagnose the problem.

These cars had a tendency to "lose" the password for the theft deterrent system. Your body control module doesnt understand your key, therefore tells your pcm to discountinue fuel supply. To reprogram the system, start the engine and let it stall. Leave the key in the run position. The theft light should flash for 10 minutes. When the light stops flashing, Turn the ignition off for 10 seconds. Turn the ignition back to the run position. This procedure tells the BCM that on the next ignition cycle, to accept the new password. Now, it should start. If not, it may require the clearing of the code, and possibly the reprogramming of the PCM, which needs to be done with a dealer scan tool or equivilant.