I have a 2000 jetta with 1.8 turbo awd engine I turn the car on just find and after 5-10 min it turns off then I wanna turn the car back on and it wount not turn on it just turns and turns I already changed the oil with fiter spark plugs and fuel filter im guessing it could be a fuel pump or a igntion control module plzzzz help asap thanks

SOURCE: 2005 jetta not getting fuel turns over changed fuel filter

Most newer cars have a reset switch in the passenger side kick panel, hope this helps

SOURCE: how do I change spark plugs on 2000 VW jetta 2.0

Here is a diagram and step to step to take out your spark plugs and re-install them. Please do not forget to rate and comment about yor experience with fixya today

2.0L (Aeg, Avh, Azg, Bbw, Bev) Engines
NOTE This procedure requires the use of the following special tools, or their equivalents:

• Spark plug wrench VAS 3122B
  
• Seal puller T10018
  
• Removal/Installation tool T10029
  
• Puller T10095
  
• Torque wrench V.A.G 1331/ (5 - 50 Nm)
  

1. Make sure you have the radio code, if necessary.
   
2. Disconnect the negative battery cable.
   
3. Pry the plugs out (arrows), then remove the nuts underneath.
   
4. Remove the nut (1).
   Pry the plugs out (arrows), then remove the nuts underneath. Remove the nut (1)
   
5. Pull out oil dipstick.
   
6. Remove engine cover.
   Spark plug applications—2.0L (AEG, AVH, AZG, BBW, BEV) Engines
   
7. Remove the spark plug connector (arrows) using tool T10029.
   
8. Remove the spark plug using Spark plug wrench VAS 3122B.
   
9. Inspect the spark plugs, as outlined in this section.
   Remove the spark plug connector (arrows) using tool T10029 and remove the spark plug using Spark plug wrench VAS 3122B (arrow)
   

1. Install spark plugs with Spark plug wrench VAS 3122B. Tighten to 22 ft. lbs (30 Nm).
   
2. Install spark plug connectors using Removal/Installation tool T10029
   
3. Check that ignition wiring and spark plug connectors are seated securely.
   
4. Install engine compartment cover.
   
5. Connect the negative battery cable.
   

SOURCE: 97 jetta wont start

Change the crankshaft sencer.

ZJ Limited

• 17989 Answers
• Posted on Nov 24, 2009

SOURCE: how to changing spark plugs on 1 8 turbo vw 2000

In here you can find one DIY: 1.8T Coilpack and Spark Plug Change (with pics)

Hope helped with this (remember rated this help). Good luck.

SOURCE: 5 error cods on my 2002 Jetta GLS 1.8 Turbo Engine

P0420= Catalyst System Efficiency Below Threshold Bank 1
P0300=Random/Multiple Cylinder Misfire Detected
P0301=Cylinder 1 Misfire Detected
P0172=System Too Rich Bank 1
P2181=Cooling System Performance
you need to write these down,have someone clear the codes in the car,then go for short ride and recheck which if any code reappears.it's like domino's affect,one sensor can start a chain affect with the others.