The drivers side seat electrical does not work. Seat won't move, car was purchased without a manual. Where are the fuses for this?

Auto Repair: How to Replace a Power Seat Motor - YouTube

? 1:44
https://www.youtube.com/watch?v=EDh-0rs5Fjo
Oct 26, 2010 - Uploaded by automdvideos
Auto Repair: How to Replace a Power Seat Motor ... 2007 - 2008 Ford Expedition/Lincoln Navigator Driver Bottom Install Video ...2003-2006 Chevy/GMC Seat Cover Install 1 of 3 - eBay Ready ...2000 Ford Explorer Front Seat Track Stuck Motor Repair - Duration: 4:39. by cubmancan 4,959 views. 4:39.
Drivers seat is dead! No power seat or heat. - TheDieselGarage.comwww.thedieselgarage.com/.../96465-drivers-seat-dead-no-power-seat-hea...Mar 22, 2010 - 2003-2005 Chevrolet Avalanche, Silverado, Suburban, Tahoe 2003-2005.... Power seat on driver side didn't work.....passenger did! Neither ...DANG electric seat ' Chevy Truck Forum ' GM Truck Clubwww.gmtruckclub.com/forum/threads/dang-electric-seat.2990/Apr 27, 2006 - 10 posts - ‎7 authors'03 Tahoe My driver seat just stopped, of corse not where I need it, the ... I have a 2003Tahoe and both heated seats are not working. ... with my seat heater on the drivers seat in my 03 Avalanche, it turns ... The driver's side on my Silverado gets way warmer than the passenger side. ... Frozen New Member.Power Seat Problems?? - Tahoe Forum - Che

Check underneath the seat for an inline fuse. It is a glass type fuse in a fuse holder that you have to push and twist to get out.-----------------------------------------------------------------------------
XPROG-M

check the fuse box as it ay just be a blown fuse, also check the wireing connectors under the seat as they may have come loose.
martyn

Check for a blowin fuse, Defective relay, Loose wires break in one of the wires, Switch could be shot, OR evan the motor has burn,t out,

Before you do any of the expensive things disconnect and reconnect the wiring to the seat I had the same exact problem with my 2009 Chevy Impala and was ready to take it to the dealer when I disconnected the power cables to it and reconnected them I found that one of the Harnesses was loose and the problem was solved

Have the switch tested for the seat and also verify the seat has power to the switch before you do any parts replacing. Power seats have more than one electric motor and it very unlikely that all would stop working. Go under the seat and locate the heavy connector that comes out of the rug and connects to the seat, using a 12 volt test light probe the connector and see that at least one of the heavy wires there is "hot", you may need the key on. If you find no power check owners manual for the location of the power seat fuses, they are likely under the hood. Good luck and hope this helped. Please rate my help for Fixya, it helps to improve my standing on the site. Thanks

Have you checked the fuse? Look in owners manual for the fuse block and see if the fuse is burnt.

Check the fuses, if those are good and that is a bench seat, test the control, if the control is good replace the electric motor.

The seat is controlled by a circuit breaker. Refer to your owners manual for location.