My 1999 Lexus Es300 shows VSC OFF display for a day or two and then disappears. The problem is intermittent. Sometimes the "Check Engine Light" also comes on. The state emission test showed an error code p1133. Can you help? Lexus dealer said this occurrs if the gas cap is not properly closed. But, I do not think it is the problem.

SOURCE: how to change lexus es300 2002 cabin air filter

I just changed the cabin filter of my ES300. I found the instructions on the manual, under airconditioning and audio. It's pretty easy to do. I bought the filter from Kragen's for $21.95.

ROBERT GARCIA

• 926 Answers
• Posted on Apr 15, 2009

SOURCE: cylinders misfire for 99 lexus ES300

no, this is a fuel quality poor or water momentany, make this test: disconnect the negative battery terminal few minutes and reconnect,run the engine, drive and check









.

ROBERT GARCIA

• 926 Answers
• Posted on Apr 21, 2009

SOURCE: Check Engine Light came on with code p0420. Dealer wants $3900 to fix "b2 manifold and front pipes. Does this make sense. Are their better alternatives. I left the dealership without fixing it and the

if your car no present any problem i think that mechanic is a thieft.

Sometimes the fuel have mixtures that make the check light on , to reset disconnect the negative battery few minutes, no go more to this mechanic,good luck

SOURCE: HID low beam headlight replacement for 2003 lexus es300

The HID bulbs are very easy to change, and can be bought online for much less than from the dealer. Check sites like xenondepot and Ebay for Phillips D2R (for reflector headlamps) HID bulbs and you can replace them yourself.

SOURCE: CD player Error 3

dear,
I have different experiance with the C.Dplayer ( error 3 ) , there is no need to remove it nor send it to the dealer ,all you have to do when you have `` Error 3 `` is to reset the C.D player , by recycling the power supply ,this can be done by disconnecting the main car battery power supply , you must also keep the battery disconnected for at least one hour . then connect the cables to the batteries ,when you start the C.D player you will hear some clicking sound ,and watch the numbers of the C.D`s in the display you will find all what is inside has been detected by the display .
and your C.D player is back to normal..

i discovered ths by chance , when I had this error in the past ,coincidently I had to replace the battery and after installing the new batteries ,i was suprised to see the player back to normal condition by its self.