Hello..i repalce the computer in my 1997 sebring convertable because it had problems it would not start..engine wont turn over..and even after i replace the distributor cap,spark plugs & wires and refebrish cumputer it still wont start.. what do you think can be the solution ?

Hi can you help me figure out this problem with my 2007 chrysler sebring, it wont start it makes a clicking sound, battery checked, fuels,and its fine.

Hi there,

You will need to extract the fault codes from your vehicle's computer, as follows:

1) Turn ignition key: ON, OFF, ON OFF, ON (leave in ON position)
2) The Check Engine light (CEL) should start flashing
3) Read codes as follows:

- First group of flashes indicate 1st digit of code (followed by short pause)
- Second group of flashes indicate the 2nd digit of code (followed by short pause)
Note: a long pause separates each fault code, then codes will repeat again

e.g. Flash, Flash (short pause), Flash (long pause)...... indicates Code: 21

4) Code 55 indicates end of CEL code output


Post your codes results here and I can assist you with the appropriate repair.

Cheers,



"If this has helped you resolve your problem, please be kind enough to leave a testimonial"