Fog light problem on nissan maxima 2005 is there a fuse

System Description EKS0058X Control of the fog lamps is dependent upon the position of the combination switch (lighting switch). The lighting switch must be in the 2ND position or AUTO position (LOW beam is ON) for front fog lamp operation.When the lighting switch is placed in the fog lamp position the BCM (body control module) receives input signal requesting the fog lamps to illuminate. When the headlamps are illuminated, this input signal is communicated to the IPDM E/R (intelligent power distribution module engine room) across the CAN communication lines. The central processing unit of the IPDM E/R controls the front fog lamp relay coil. When activated, this relay directs power to the front fog lamps. OUTLINE Power is supplied at all times ? through 15A fuse [No. 43, located in the IPDM E/R (intelligent power distribution module engine room)] ? to front fog lamp relay, located in the IPDM E/R (intelligent power distribution module engine room) ? through 15A fuse [No. 34, located in the IPDM E/R (intelligent power distribution module engine room)] ? to CPU (central processing unit) in the IPDM E/R (intelligent power distribution module engine room). Power is also supplied at all times ? through 50A fusible link (letter f , located in the fuse and fusible link box) ? to BCM (body control module) terminal 55 ? through 10A fuse [No. 21, located in the fuse block (J/B)] ? to BCM (body control module) terminal 42. When the ignition switch is in ON or START position, power is supplied ? to ignition relay, located in the IPDM E/R (intelligent power distribution module engine room) ? through 10A fuse [No. 1 located in the fuse block (J/B)] ? to BCM (body control module) terminal 38. When the ignition switch is in ACC or ON position, power is supplied

Check fuse. Switch may be bad. You may be able to confirm
bad switch with a jumper arround the switch. There may be a relay
for the fog light, and it could be bad. Again a jumper around the relay would confirm.

check for busted fuse.

fog lights not working 2005 maxima. is there a fuse for the fog lights?

CHECK FUSE TO TURN SIGNAL OR COMBINATION SWITCH.IF FUSE GOOD PROBLEM COULD BE IN COMBINATION SWITCH.

Check for the fuses,and also check the bulbs

check your fuses

jorgeva: on the driver's side to gain access, you must remove the air cleaner assembly. At that point, you can see the back of the light which has a plastic cap. Rotate this "counter clockwise" and you can pull it back from the back of the lamp housing. From there you will see how the bulb it self is plugged in, which is obvious. Unplug it. There is a "spring "like latch retainer to hold the bulb in place. Unlatch it, remove the bulb and install the new bulb.
CAUTION!!!!!!! DO NOT TOUCH THE GLASS AREA OF THE NEW BULB! Only handle the rear section. Reassemble in the reverse order.
The right side will require the removal of the windshield washer tank.
I trust this will have answered your question. If you would, let me or FIXYA know if I have solved your problem......

Replace the bulb. It may look good but its NOT. See it all the time with Maxima fog lamps.

where is the fuse for the fog lights on a 2005 nissan maxima