You probably need to replace the ignition switch (located at the bottom of the steering column). You can start by making sure the switch has not come loose from the column and that the rod connecting it to the key mechanism has not come loose or is out of adjustment.
SOURCE: Trunk lid closer will not work, fuse is good.
prbably looking at replacing the motor and gear assembly, gm had lots of problems due to slamming of the lid too hard
SOURCE: 91 Olds 98 Regency elite once in a while the
Based on the information you have given to this point, I am just going to give you a few possiblities. Have you had a tune up done recently? Air filter been checked or changed? I am not in any way trying to sound sarcastic so I apologize if I come off that way.Those would be my first things to inspect if I were ask to look at your car. I would also check fuel pressure and inspect the fuel pressure regulator.I would consider these things and go from there. I Hope this helps you but please let me know if you need more information on what to do next but I may need some more information at that time also .
SOURCE: a/c compressor relay location and how to identify it . No diagram
under hood fuse box-check the label it is in there and will be identified.
SOURCE: I have a 1992 olds
in my experience finding specific directions on how to do that are nearly impossible to find due to the strict EPA regulations on the use of refrigerant. but when i replaced the evaporator core on my tahoe i found it helpful to go on to youtube and search how to remove the dash. once the dash is out disconect the lines going to the evaporator core and the heater core from the engine side of the firewall. from inside the vehicle remove all screws securing the heater box to the firewall. you have to search for one or two hidden screws. looking from the engine side may make them visible. the heater box should pull out easily if not you missed a screw. once out of the vechicle remove all screws hold the box halves together, mine had about fifteen going all the way around it. open it up remove the evaporator core, clean any dirt, leaves etc. out of the box. replace core and reinstall. honestly not a very difficult job, but it is time consuming. hope this helps.
243 views
Usually answered in minutes!
Will not start or will not crank?
is there a light on the dash that says security when you turn key on?
×