Where can i find an ignition switch diagram for a 1994 grand cherokee?

http://www.commandocaralarms.com/wiring/1994/Jeep/Grand-Cherokee/print_wiring_chart.asp

1994 Jeep Cherokee SE 4 0L System Wiring Diagrams

Hi Andrew:
The 1994 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running. I have an '93 GC 5.2L V8...

The following wiring diagram and electronics circuit contains detail schematics of The 1994 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Here's what I found;

Constant 12V+ Pink/Black Ignition Switch Harness Starter Yellow Ignition Switch Harness Ignition Dark Blue/Gray Ignition Switch Harness Ignition 2 Red/Black Ignition Switch Harness (for AC) Accessory Black/Orange Ignition Switch Harness

the key is just the lock assembly the actual ignition switch is behind thelock take the plastic covers off steering housing the ignition is the black square housing held on with tamperproof torx screws easy to replace

Its possible that you find this information in the ZJ-Secc-8W-Wiring-Diagrams Repair Manual.

Good luck (remember comment and rated this).

Switch ,relay resistors or motor is shorted to ground.
Start with the switch and remove each one until it stops . test the item and it will probably be the culprit. Now remember most vehicles while running will have blower motor run at a low speed all the time.
The only time this should not happen is when the ignition is off.

Review this documents about Jeep ZJ Grand Cherokee:
- ZJ-Secc-8S-Power-Windows
- ZJ-Secc-8W-Wiring-Diagrams (page 134)

I really hope helped with this (remember rated this help) Good luck.

You have a bad fuel pump, not ignition switch.

Providing that the motor turns when you turn the key, I'm going to guess that you may have a bad ignition switch or a poor connection somewhere between the key and the pump. I just checked the only wiring diagram I have and am seeing two fuel pump relays. This diagraqm has lied to me before, but it may be worth checking this out!

Check the starter, selinoid, and then the ignition switch if the motor will not turn over. If it turns over without fire check the ignition coil and then the distributor.