1998 Chrysler Sebring convertible Not shifting into drive check engine light came on, error code PO715

https://www.amsoil.com/lookup/auto-and-light-truck/1998/chrysler/sebring-convertible/2-5l-6-cyl-engine-code-h-eeb-h/

It's not that simple, this code is a catalytic converter efficiency code. Possible causes are bad Oxygen sensor or bad catalytic converter. You will need to have a competent Technician determine which one.

I suggest you get one of those manuals people get nowadays to do it yourself..
My nephew use it to repair my car and it's totally repaired now. Here's the website he bought it from.
it's reliable-store.com they also have live c hat options to help you. other wise try manualslife.com but there's not live chat there

try replacing the TCM as code p0700 refers to specifically and it puts the light on.

2006 Sebring Convertible - Transmission Codes - P0700, P0720, & P0731....
2006 Sebring Convertible, started while driving around town - transmission did not want to shift and CEL came on. Stopped, checked transmission fluid and looked for anything obvious. All fluids good, nothing obvious. About 5 miles from home, drove back roughly 15-20 mph. Only other issue that had came to mind was the alternator had been making a whining noise for some time, probably 3 months or so - had mentioned to wife that we should replace it before it completely failed. Found one reference on the internet that the alternator could cause weird electrical conditions / interference if bad - leaking voltage back through ground. Thinking the alternator likely needed replacing anyway, I replaced it and cleared codes - all issues were solved - no more alternator whining and all transmission issues resolved. Replaced alternator on Sept 9, 2019 today is Sept 12, 2021 and still going - I think its safe to say the alternator was the culprit in this instance.

run the fault codes to find the reported fault
engine lights report on engines and transmissions
could be actuator or vacuum to actuator, dirty transmission oil or pump pressure problems

Shifter was broken. Still under warranty, so dealer replaced. Works fine. According to a dealer service person trying to assist this is not an uncommon problem with Chrysler/Dodge products.

The check engine light came on probably because it detected an error with your car. In this case, it sounds like the error is with your transmission. Most likely a bad solenoid. Bring the car to a place like Autozone where they will scan your car for free to retrieve the code(s) that will point to where the issue is.

shift lock switch. this switch is usually connected to a little box on the brake pedal. Look about half way up the pedal from the foot pad and make sure the wires are still intact.

Is the gear shift button stuck in, if so hit the gear shift a couple of time and that should unstick the botton, allowing you to remove your key