I have 2000 lincoln ls, from my front driver side window switches i could lower my passanger front window but it won't go back up, i have to roll it up from my passanger side switch.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
How about when the radio is on & the key is off or in your hand,if you open either front door does the radio go off & do you lose the delayed window feature assuming you have that If so you problem is a delayed accy relay Next would be the front door switches I will give you credit for what you tried but fail to see why you would switch motor from door to door,they work powered directly or they don't I would think your battery would have gone dead by now if the relay failed to time out or go to sleep
I ran into a problem like that on a ford focus , the alternator was the problem . Test or have the charging system tested . Check for DTC'S - diagnostic trouble code's .
since it works from the left button its not the motor, so it would have to be the switch that,s bad. replace right side switch and you should be back to proper operation.
B1233 - Glass Break Sensor Failure B1234 - Mirror Switch Invalid Code B1235 - Window Feedback Failure B1236 - Window Feedback Loss of Signal
Sounds to me like the connector for the wiring harness from the body into the door has come unplugged. Am I right in guessing that you have at least one window that won't roll up or down and you can't adjust at least one of your electric mirrors (On the same side as the faulty window).
Drop me a comment back on here, let me know what you find and if I can assist further
Remove & test all door window switches that
operate that window
If they are good, then remove the inner door panel
& check for a broken regulator cable & if necessary
unplug & put 12V directly to the motor to test it
If you replace or lube anything, you will need to do a
Door Window Motor Initialization
You push window button to second detent & hold until
glass stalls into top run,then hold 2 more seconds
If you do not ,you won't have the one touch feature
×