04 Dodge SRT 4 crankshaft sensor

Top part says you want Camshaft Sensor, but the bottom says you want Crankshaft Sensor??

Camshaft
https://www.google.com/search?q=2012+dodge+caliber+3.0+camshaft+sensor+location

Crankshaft
https://www.google.com/search?q=2012+dodge+caliber+3.0+crankshaft+sensor+location

..

https://www.justanswer.com/dodge/2665g-crankshaft-position-sensor-located-2005-dodge-stratus-2-4.html

Ok, take a look at the link. My database didn't show a location for some reason?

Crankshaft Position Sensor Replacement Dodge Stratus Chrysler Sebring...

REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION).

Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.

On the 4.7L, the cam position sensor is located on the right cylinder head (thats the passenger side) toward the front below the valve cover gasket. Not on the front of the head but on the side where the exhaust manifold is attched at the forward end of the head. The crankshaft position sensor is located on the same side (right) but is at the opposite end of the engine between the bell housing and the block. The crankshaft position sensor can be replaced without removing the engine or transmission, it just looks tight. Also, on the crankshaft position sensor, it slides out of a rubber gromet. Here's a few pics to help.

BETWEEN THE PAN AND THE FLY WHEEL

I'm sorry can you provide more details to you problem please.

the iat sensor is located in the fresh air duct connected to the air filter in front of the fuse/relay control panel. to remove the iat sensor, renive the air filter cover and using a pair of wire cutters remove the small steel band holding the sensor in place. then by pulling on sensor it will come out. when replaceing sensor be sure to install new metal ring on new sensor to secure it in place.

inside the tank

What code number? It could have a wiring short or open to the PCM or to ground. Cam could be out of time, check the timing belt.