Need installation instructions to replace SW-6538, range sensor, for 2005 ford focus

This process is not difficult at all and anyone can easily do it - you don't have to be too tech savvy. Anti spyware programs have been created in such a way that they are very easy to use and they guide through the entire process of finding and eradicating the spyware once you run them. Hence, if you notice your computer is running slower than normal or if you see number of pop-ups or if you just want to avoid identity theft, you should go for good spyware removal software. Download one and follow the process as stated by the program. Do not forget to update your program and scan your computer regularly for spywares. Once you have got rid of those notorious spywares, you can have your computer back to normal

Only have 2002 right now

SECTION 307-01: Automatic Transmission/Transaxle 2002 Focus Workshop Manual
IN-VEHICLE REPAIR Transmission Range (TR) Sensor Removal

1. Disconnect the transmission range (TR) sensor electrical connector and the selector lever cable.

1. NOTE: Failure to hold the shift lever while loosening or tightening the manual shaft lever will transmit rotational torque to the TR switch and shift mechanism.
   Remove the TR sensor (automatic transaxle removed shown).
   1. Remove the manual control lever.
   1. Remove the bolts.

1. NOTE: Failure to hold the shift lever while loosening or tightening the manual shaft lever will transmit rotational torque to the TR switch and shift mechanism.
   Install the TR sensor (automatic transaxle removed shown).
   • Loosely install the bolts.
   • Install the manual control lever.

1. Using the special tool, align the TR sensor and tighten the bolts.

1. CAUTION: Do not use air tools on this bolt. Hold the manual control lever while tightening the manual control lever bolt, failure to the manual control lever shaft could occur.
   Install the manual control lever.

1. CAUTION: Check the manual control lever is in position "3" same as "D" position.
   Adjust the manual control lever to TR sensor "D" position.
   1. "1" Low 1
   1. "2" Low 2
   1. "D" Drive
   1. "N" Neutral
   1. "R" Reverse
   1. "P" Park
   • When in position "D" the marks on the manual control lever line up with the marks on the TR Sensor.

1. Connect the selector lever cable and the TR sensor electrical connector.