SOURCE: cruise control installation
Not really sure on parts pricing (probably very expensive) but very complicated and work intensive to install... Need to get the engine computer reprogrammed for cruise control, install all the wiring (to the brake light switch, the speed sensors, etc...) install the servo/vacuum motor and cables to the throttle assembly...
SOURCE: car keeps dying
Trouble Code 33 and 34 are the MAF/MAP Sensor
Circuit. It sounds like you've replaced that sensor already. Did you also have the code 34 before putting in the new sensor?
Or did this code start after it's replacement? Any other codes appearing?
Troubleshooting it would depend if it has the Speed Density
Update. The dealer should be able to provide that info.
Here's your fault code list:
13
oxygen sensor circuit
14
coolant temp sensor circuit (high temp)
15
coolant temp sensor circuit (low temp)
21
throttle position sensor (TPS) circuit (high signal)
22
throttle position sensor (TPS) circuit (low signal)
23
manifold air temp (MAT) circuit (low temp)
24
vehicle speed sensor (VSS) circuit
25
manifold air temp (MAT) circuit (high signal)
31
wastegate solenoid electrical circuit
32
exhaust gas recirculation (EGR) circuit
33
mass air flow (MAF) circuit (gm/sec high)
34
mass air flow (MAF) circuit (gm/sec low)
41
cam sensor circuit
42
C3I EST or bypass circuit failure
43
electronic spark control (ESC) circuit
44
oxygen sensor circuit (lean exhaust)
45
oxygen sensor circuit (rich exhaust)
51
PROM error
52
calpak error
55
ECM error
SOURCE: Location of camshaft position sensor on a 2001 Hyundai Elantra wL
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
SOURCE: I need an Owner's Manual for a Hyundai Tucson
You can purchase on eBay (www.ebay.com). Contact the seller first to make sure it covers diesel.
SOURCE: Hyundai Tucson
The transmission filter is inside the transmission. You have to drain out the oil and remove the transmission pan and gasket. The filter is made of metal guaze and is screwed/bolted to the underneath of the valve body.
62 views
Usually answered in minutes!
×