SOURCE: Adjusting the low beam headlight
its all the same the headlight is a complete unit you adjust both/ look for screws behind the headlight one each side one is for horizontal annd the other is for vertical Please rate my response thank you very much
SOURCE: belt does not retrack
without taking the housing apart......the return spring is more then likely damaged/pinched, or the belt got twisted inside the housing
SOURCE: broken driver seat track bracket hinge assembly
track its self bolts on after u take the seat out turn it upside town and un bolt the track u can pick them up at any junk yard or salvage yard
SOURCE: my drivers side seat belt is not retracting on my 2005 hyundai el
Most of the time this happens because the belt gets twisted behind the B pillar trim panel. The lower portion of the panel that the belt goes behind can be removed enough to see behind it by gently pulling outward, it is held in place with plastic clips. If the belt is twisted up in there, untwist it and snap the panel back in place.
Testimonial: "that was it. thanx!"
SOURCE: Correct torque on cylinder head bolts for Hyundai Elantra 1.8GLS
You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM
67 views
Usually answered in minutes!
×