The blower blows air thru vent near glass-defrost vent and side-in door near window only. The freon has leaked out. Repair man says ac controller needs replacement. is this diagnosis correct.

There are several possible reasons why your blower, vent, defrost, AC, and heater might stop blowing air:

1. Blower Motor Failure: The blower motor is responsible for blowing the air through the vents. If the blower motor fails, you will not get any airflow from the vents.
2. Blower Motor Resistor Failure: The blower motor resistor controls the speed of the blower motor. If the resistor fails, the blower motor may stop working or only work at one speed.
3. Fuse or Relay Failure: A blown fuse or faulty relay in the blower motor circuit can prevent the blower motor from working.
4. Control Module Failure: The HVAC (heating, ventilation, and air conditioning) control module is responsible for controlling the blower motor and other components. If the control module fails, it can prevent the blower motor from working.
5. Vacuum Leak: If your vehicle uses a vacuum system to control the vents, a vacuum leak can prevent the system from working properly.
6. Broken Blend Door: The blend door controls the direction of the airflow. If the blend door breaks or gets stuck, the air may not flow through the correct vents.
7. Wiring or Connector Issues: Faulty wiring or connectors in the blower motor circuit can prevent the blower motor from working.

Most common reason is a faulty blend door under the dash.
The blend doors direct air thru the vents and also control temp.
You may need a shop manual to diagnose the actual problem and repair it.

the actuator to the defrost door is inop. try running the climate system thru all the modes ac heat defrost vent off etc, maybe it will begin operating . look for any vacuum leaks

the heater vacuum motor and lines needs to be checked.Also get the blend door checked.

NO HEAT ON FLOOR VENTS

---------

As per your problem mentioned. There are few solved help links to troubleshoot these problems. Go through the list and Click the link below:----

2000 Toyota Avalon: No heat on Passenger Side?

http://whatisbyme.blogspot.in/2012/05/2000-toyota-avalon-no-heat-on-passenger.html

------------

No heat on Oldsmobile Silhouette?

http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html

------------

Heater blows cold?

http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html

-----------

Heat blows cold on drivers side and hot on passenger side?

http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html

----------

Hot air on the driver's side vents only?

http://repairhelpcenter.blogspot.com/2012/01/hot-air-on-drivers-side-vents-only.html

--------------

Temperature gauge does not move and no heat when heater is ON?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html

-----------

1992 Toyota Camry: A/C Control light Flashing and A/C not Blowing Cold?

http://technoanswers.blogspot.in/2012/04/1992-toyota-camry-ac-control-light.html

--------------

No heat, blower blows only cold?

http://technoanswers.blogspot.in/2012/02/no-heatblower-blows-only-cold.html

----------

Ford F150 Ac only blows through defrost vents?

http://technoanswers.blogspot.com/2012/01/forf-f150-ac-only-blows-through-defrost.html

----------

Dodge A/C come out of defrost vents only?

http://technoanswers.blogspot.com/2012/01/dodge-ac-come-out-of-defrost-vents-only.html

---------

Ac vacuum line on dodge cummins?

http://technoanswers.blogspot.com/2012/01/ac-vacuum-line-on-dodge-cummins.html

---------

Ford ranger AC blows cold through defrost vents instead on cabin vents?

http://technoanswers.blogspot.com/2012/01/ford-ranger-ac-blows-cold-through.html

----------

2005 Chrysler PT Cruiser: A/C Blows Warm?

http://whoisbyme.blogspot.in/2012/06/2005-chrysler-p8t-cruiser-ac-blows-warm.html

-------------

2009 Mercury Grand Marquis: A/C blows Cold From Defrost Vent Only?

http://whoisbyme.blogspot.in/2012/06/2009-mercury-grand-marquis-ac-blows.html

-----------

AC not blowing through Vents on 2007 Chevy Trailblazer?

http://schematicsdiagram.blogspot.in/2012/04/ac-not-blowing-through-vents-on-2007.html

----------

Passenger side temperature is warm air out of dash vents?

http://schematicsdiagram.blogspot.in/2012/04/passenger-side-temperature-is-warm-air.html

----------

These will help.

Thanks.

Usually this is a problem with the blend doors under the dash. You either have a vac leak, a dead motor, or a faulty door.
The control opens and closes the doors to direct air thru the heater core and evaporator core along with directing air thru the vents.
When a problem occurs, the default position is the defrost vents to make sure the windshield remains clear.
You can do an internet search for "repair durango blend door" for more info.

Look for a vacuum line passenger side rear under hood near hood hinge area. Follow this line back to the intake manifold. checking for crack and leaks if any breaks in this line repair them this should fix your problem if not check all vacuum lines under the dash as well as the vacuum diaphrams that control heater door operations. if you have a hand vacuum pump you can check all these at (previous found) intake connection for the heat controls

Sounds like the blend door actuator which diverts air from defrost,to bi-level,vent etc. It's vacuum driven and when it fails, it's usually an indication of a vacuum leak. To trace the leak, start the car, turn the AC on high and starting at the firewall in front of the passenger's side, trace the vacuum lines backward until a leak is detected. If no leak is detected, it's very likely that the blend door actuator is faulty and needs either repair or replacement. Best of luck.
Greg

check or loss of vacuum to mode control switch in dash ac control. these are not blend doors, they are air flow control, a blend door controls the air temperature not where it comes out.

The problem is with the blower door actuator. It's vacuum driven and controls the air flow from the defrosters, vents, and floor. With the AC on, open the hood and check the lines (very skinny rubber lines) at the firewall in front of the passenger and work back ward. You're looking/listening for a vacuum leak, either a pinhole or maybe a worn end in need of repair.

Check under the hood for a vacuum leak near the firewall on the passenger side of the car. The blender door is vacuum operated and a leak would prevent the door from changing which vents the air blows. Hope this answers your problem. All the best!
Greg