At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I figured my license plate lights were burned out, so I replaced them today, They still don't work. I checked all the fuses...the cig lighter fuse was burned out...replaced it, still no plate lights. Did I miss a fuse?
Probably not... For some reason license plate light wiring and sockets are VERY prone to corrosion. Make sure to check the light sockets and try to get to the wiring close to them, your problem is more than likely very close to the lights.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
According to a post on Traverse Forum, the issue might not be with the bulbs themselves, but rather with the connectors that slide onto the bulb. These connectors may be corroded, which could prevent the bulbs from working . Another possibility is that the lens the bulb attaches to may be full of dirt, especially if you live in a dusty area .
If neither of these solutions work, it's possible that there is a problem with the fuse for the license plate lights. The license plate lamps are powered by the 10 amp left parking light circuit fuse located in the under hood fuse panel. If any of your parking lamps on the left side are out, this could be the problem. If those lights are working, then the fuse should be good. The fuse is easy to get to, so it's worth pulling it out and reseating it or replacing it . Fuse box location and diagrams: Chevrolet Tahoe (2007-2014) - YouTube
Nov 11, 2011 - The licence plate lights are in the same line as your tail light wiring assembly. I assume your ... Previous owner cut wires going to lights for license plate. ... 1996 ford explorer license plate fuse ... 09@1998 ford f150 fuse box.
Do the park lamps work ? license plate lights get power from same fuse ! Check ground wire ! use a volt meter an do voltage drop test ! Voltage Drop Testing The fuse for the license plate lights is in the under hood fuse box -engine compartment ! fuse #12 RT PRK LAMP 10Amp .
The licence plate doesn't have a fuse, it comes on when you put your lights on, if you have your park lights on and the plate light isn't working then generally it's just a bulb, see what you can find, cheers good luck
normally the number plate light is on the same fuse as the park lights . I would be looking for a fault in the number plate area ( broken wire or blown bulb or bad/ no earth)
the bulb is most likely burned out. there are a few types of license plate lights out there. some where you have to replace the whoel unit and some that have replaceable bulbs. both you can find at your local parts store.
Sounds like you may have a wiring issue. I would cut the wires at the tag lamps, leaving enough to splice in new ones. Then pull one of your tail light assemblies out and, using a test light which is available from most parts stores for $5-10, figure out which wire is hot with the parking lights on. Splice a wire from there to your tag lamp socket. Then splice the other wire to the ground circuit at the tail lamp or find a good ground to wrap it around somewhere else (usually just about anything metal). Just find a bolt somewhere, back it out a bit and stick some of the stripped wire behind it at tighten it back up.
fuse for 2003 GMC envoy license plate light
fuse for 2003 GMC envoy license plate light
which fuse is the licence plate light fuse
checked fuses and they are all good
×