I have a 2000 land cruiser with the factory tape/cd 6 disc changer system. I removed it and am trying to connnect a pioneer DEH 3200UB head and no matter what i do i cannot get the wiring right. I tried wiring it into the old wiring, no luck, i tried buying multiple wiring harnesses no luck, i cant find any that fit at all and i can find no correct wiring diagram for them either. PLEASE HELP!!!!

SOURCE: Trying to remove and replace rear brake rotors

First, make sure your parking brake is off.
Remove the rear caliper and then the brake pad housing. In the center hub of the rotor the parking brake shoes are located. The may need to be loosen first. There is a hole between 2 of the studs you need to align at the bottom. Look in the hole with a flashlight and find the star wheel. Use a screw driver to turn the wheel up a few turns to loosen the parking brake shoes from the rotor hub.
After that there are 2 threaded holes in the rotor near the studs you put two 8mm bolts in and slowly tighten each and it will pull the rotor off the hub. They rust up pretty bad so use penetrating oil on them.

SOURCE: wire colour coding for radio Holden Nova LF

Car Radio Constant 12v+ Wire: Blue/Yellow
Car Radio Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Violet
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Blue
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White

wayne

• 364 Answers
• Posted on Jan 01, 2010

SOURCE: aftermarket stereo wiring harness does not fit oem

Theres a standard amongst most stereos, so if these colors apply, then you will be right,
Red is Ignition power
orange is direct power
Black is earth
blue is for phone
White is for electric arial
then there will be four coloured wires with matching color trace wires, these are the speaker wires.
Hope this gets you going, good luck.

SOURCE: the rear wiper workes if

Hi

You may want to check one thing. Roll the rear window down a few inches and then rolll it back up. There must be a relay switch to tell the car the window is open. If that does not work, it might be the relay switch.

There are three possible points of failure; the motor, the parking switch, and finally the switch that turns it on.
Obviously, the motor is located in the hatch itself but also there will be a parking switch that supplies power to the motor after the user switch is turned off and until the blade is in the park position. The user switch is of course located on the dash or in a stalk on the steering column. Check for voltage with a multimeter at the motor and/or continuity of it. You should be able to eliminate the items that are working in 20 or 30 minutes.

Please get back to us if you have further query else please accept the suggestion.
Thank you for contacting fixya.com