Wondering if there is a fuse for the Power Windows for a 91 Camry? if so where would I find it,looked in all the obvious places so far.The Driver side master window and door lock control does seem to be getting any poer from the battery.It is acting like a fuse issue.I have hooked leads to the battery and bypassed the wiring from the battery and i can get the windows to work.

I had the same thing happen on my 1989 model a few years ago, the part from the salvage yard was junk and when I bought a new one from the dealer at 120 dollers it worked fine. Since this is the master control it must be an excat match. Have you looked at the fuses and determined none of these are blown? Not much else it can be unless the wiring harness is bad. Make sure all the pin connectors on the switch are straight and clean.

most like its behind the passanger glove box, hope this helps ( rate me thanks )

Log onto Autozone.com and enter yr/mk/model of vehicle and you will be able to view Chilton's online manual for free.

replace the power window master switch and chances are the lock actuators are bad. replace as neccessary. happy holidays

More than likely, you have a broken wire or two between the body and the driver side front door. This is a very common issue with those cars when tey get older.

Check with a test light to see if you have power at the tail light socket. If you don't, check the fuse. If the fuse is burnt, that's your problem. If it's not, check for power in the wires. Keep testing from back to front unil you find power. If one is broken or shorting out, the most likely place to find it is under the car, near the back where gravel stones can damage them.

one fuse box in cab one under hood.

If there is anything, that is in any way "burnt", it needs to be replaced.
I would try a local auto recycler before I ordered a new light failure sensor.

try a higher amp fuse

It is rare that the power window relay will fail. Personally, I would look to see if there is power at the master switch on the driver's door. Anywhere. If the is NO POWER, you have a broken wire between the door & the LF kick panel where the wires come thru the body into the door shell. If there is power, the master switch is narmally the culprit