REPLACING SPARK PLUG WIRES AND PUT THEM IN ORDER

at the factory they put numbers on top of the coils to
get the spark plug wires in the right order , but when
you replace the coils it does not matter the numbers they
all work the same what it matter is to put the right wires in it
3.8 V6 the order is in front of the car the first coil two spark plug wires # 1 and # 4,second coil #5 and #2 the next coil #3 and #6 now in front of the car wires are front left to right you got
# 1# 3 # 5 on the back of the engine you got from left to right #2 # 4 #6 you get them wrong the car will misfire or it won't start ... good luck..

It can be faulty or dirty spark plug itselfd.Also for reference get the fuel level checked.Is the fuel tank is empty or near to empty.
Try cleaning the spark plugs and then see if that is helpin.On some cases the black carbon layer gets collected on the spark plugs and that causes the problem,so cleaning the plugs help.But if its not helping,then spark plug has to be replaced.Spark plugs get power from ignition coil to ignite sparks.If ignitioncoils are faulty then also there will no spark.--------------

To troubleshot and confirm the issue,i suggest you to go through the help links provided below,check the procedure and it will help you to confirm the issue in your case.
----------
Click the link below:------

Car cranks, has spark but will not ?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

-----------

The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

------------

How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

---------------

How to Perform a Basic Engine Tune Up-Spark Plug and Wire Change

http://schematicsdiagram.blogspot.com/2011/08/how-to-perform-basic-engine-tune-up_01.html

----------

Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

---------

How does the spark plug wire go on the distributor cap in 1991 Mitsubishi Mighty?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

------------
No spark on 2008 Chevy Avalanche?

http://schematicsdiagram.blogspot.in/2012/04/no-spark-on-2008-chevy-avalanche.html

-----------

How does the spark plug wire go on the distributor cap in 1985 Pontiac sunbird?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wire-go-on.html

--------------

Ford Plug Wires Not Coming out?

http://whoisbyme.blogspot.in/2012/06/ford-plug-wires-not-coming-out.html

--------

Ford explorer has no spark?

http://schematicsdiagram.blogspot.com/2011/12/ford-explorer-has-no-spark.html

----------

Chevy impala spark plug firing order diagrams?

http://technoanswers.blogspot.in/2012/02/chevy-impala-spark-plug-firing-order.html

------------

How to gap spark plug on Chevy Impala?

http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------

Spark plug Replacing for chevy impala?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

Chevy s-10 blazer 4.3l Spark Plug Firing Order?

http://howtobyme.blogspot.com/2011/12/chevy-s-10-blazer-43l-spark-plug-firing.html

----------------

1982 dodge rampage Spark plugs Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/1982-dodge-rampage-spark-plug-firing.html

----------------

2006 Suzuki Forenza Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

------------

1983 Ford Ranger Spark plug firing order?

http://schematicsdiagram.blogspot.com/2011/12/1983-ford-ranger-spark-plug-firing.html

--------

Firing Order for 1991 Lexus ES 250?

http://schematicsdiagram.blogspot.com/2011/12/firing-order-for-1991-lexus-es-250.html

----------------

Firing order for 1992 Chevrolet 5.0 engine?

http://schematicsdiagram.blogspot.com/2011/12/firing-order-for-1992-chevrolet-50.html

-----------

How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

-----------

How to remove rear spark plugs on 1991 Buick Regal?

http://howtobyme.blogspot.in/2012/02/how-to-remove-rear-spark-plugs-on-1991.html

---------------

These details will help.

Thanks.

For spark plug problem, click the help links provided below: ---
Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

------------
How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

-------------
Car cranks, has spark but will not start?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

------------------------
The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

----------
How to gap spark plug ? http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------
Spark plug Replacing for?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

-----------
How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

---------
How does the spark plug wire go on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

---------
Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

-----------

This will help.
Thanks.

It sounds like the spark plug wires are not plugged into the correct place on the distrubutor. take the distributor cap off and crank the engine over. Make a note of which direction the rotor spins. (Clockwise, or Counterclockwise) then find the firing order for that engine. Sometimes the firing order is on the intake manifold. (if you tell me which engine it has, the 4 cylinder 2.0, or the 6 cylinder 2.5; I could post you the firing order). Now on the distributor cap there is one wire post that has the #1 on it, that would be where you put the spark plug wire from cylinder 1. Following the rotation of the distributor rotor, you would put the spark plug wire for the next cylinder in the firing order after the #1 wire, and so on.

pull off plug grabbing it as close to spark plug as you can. Using socket rotate counterclockwise and remove plug. Be careful putting plugs back in and thread by hand first. Then torque as plug box says as it depends on if you have a washer or not.

If you replaced the distributor cap then there is a high possibility that you put the wires in the wrong firing order on cap.

If all you did was replaced the plugs, then I would pull each one out and recheck the Gap sizes with a feeler gauge. Also check to see if the spark/coil plug wires are touching metal or each other, which can cause the spark to arc out of the wire and never get to the spark plug. If I suspect an arc and do not see a physical problem, I wait until nighttime and look under the hood while engine is running...they stick out like a sore thumb. Also make sure that you did not put the wrong plugwire to the wrong spark plug.

When you change your plugs, you should also replace wires, cap and rotor.

2003 Chevrolet Malibu 3.1L SFI OHV 6cyl
Spark Plug Wires - Removal & Installation

3.5L Engine

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the wire could be damaged.
2. Remove the intake manifold cover, if required.
3. Disconnect the left side spark plug wires from the spark plugs.
4. Disconnect the left side spark plug wires from the ignition coil.
5. Remove the spark plug wire clips from the Manifold Absolute Pressure (MAP) sensor bracket and the heater inlet and outlet pipe tab.
6. Remove the spark plug wire assembly.
7. If replacing only one plug wire, open the retaining clips and remove the appropriate spark plug wire.
8. Disconnect the right side spark plug wires from the spark plugs.
9. Disconnect the right side spark plugs from the ignition coils.
10. Remove the spark plug wire assembly.
11. If replacing only one plug wire, open the retaining clip and remove the appropriate spark plug wire.

To install:

1. Install the spark plug wire assembly.
2. Connect the right side spark plugs to the ignition coils.
3. Connect the right side spark plug wires to the spark plugs.
4. If replacing only one plug wire, open the retaining clip and install the appropriate spark plug wire.
5. Install the spark plug wire assembly.
6. Connect the left side spark plug wires to the spark plugs.
7. Connect the left side spark plug wires to the ignition coil.
8. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab.
9. If replacing only one plug wire, open the retaining clips and install the appropriate spark plug wire.
10. Install the intake manifold cover, if required.

Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system



Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 2.4L Engine Firing order: 1-3-4-2 Distributorless ignition system



Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system


Fig. 3.5L & 3.9L Engines Firing order: 1-2-3-4-5-6 Distributorless ignition system


I really hope help you with this (remember rated this help) Good luck.

I can't tell if you need to know how to replace the spark plugs or just need the wiring diagram, so i'm giving you a link to a "how to" video.
http://www.wonderhowto.com/how-to/video/how-to-replace-spark-plugs-203687/

Since you didn't memorize the wiring order, here is a diagram...

yes it does matter, big time.

You start by putting the spark plug wire for #1 on the distributor, on the #1 spark plug. #1 is usually the first plug in the rear on the passenger side. Then figure out which way the rotor rotates, usually clockwise. Then put the plug wires on in the order of the firing order. It is not in numerical order.

If you did not take them off already, just do one at a time.

Not sure what you're asking. The only order that matters is the order of the spark plug wires. There isn't an order for the spark plugs themselves. So are u looking for the order of the spark plug wires?