Not realy a problem. however... I had a minor accident and my front fascia on my 2000 Mustang GT was slightly damaged (dislodged from the brackets at the front fenders). It appears there is no major damage. Now the problem: I intend to remove inspect/repair as needed and reinstall. Before I remove the fascia I would like to know (with pictures if possible) the proper installation requirements.

SOURCE: 2006 Mustang GT Convertible

The rear window for that top is a seperate curtain.
Replacement is best left to a professional.
You should cantact an automotive trim shop (upholstery) for them to quote it.

The way it is replaced, you have to take the top loose, roll it forward, replace the window curtain, reinstall the top. Depending on the condition if the top, it may need replacement also. That is best determined by the shop that does the work.
This is not recommend as a DIY project. I worked in a trim shop for years, and they are not easy.

SOURCE: 2000 Ford Explorer AWD purchased with different size tires

It is true that driving with different size tires can damage the transfer case, depending on how long it was driven like that. But--- even if the tires are the same size it can cause this. if the tires are worn and two tires are new the circumference of the tires must not be more than 1/2 inch difference from each other, take a tape measure and put it around the tire in the center and measure the difference of each tire

SOURCE: need diagram to reinstall serpentine belt for ford

I can't find that Ford had a 3.6L in 2000 for Mustang.
Here's a link to a 3.8L
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7002

Here's a 4.6L diagram
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S8016

Testimonial: "thank you so much!!!!!!!"

Mike Raatz

• 435 Answers
• Posted on Jun 08, 2010

SOURCE: how do i remove the back seat to my 2000 ford

On the seat bottom left and right of center there's a release clip. (see photo) Carefully push the release with a flat screw driver and pull up doing one side at a time.
Once the seat bottom is removed there's 2 bolts holding the seat back in place, remove the bolts and lift the seat back straiting up.

SOURCE: 2002 mustang GT serpentine routing

Hope this helps ya.. Cobra... :-)


Item Part Number Description 1 10344 Generator pulley 2 8620 Drive belt 3 8A528 Water pump pulley 4 3D673 Power steering pump pulley 5 63126 Crankshaft vibration damper 6 2E884 A/C clutch pulley 7 6B209 Drive belt tensioner 8 19A216 Belt idler pulley 9 19A216 Belt idler pulley