There should be 2 screws that hold the light lens in place,that you take out to get to the bulbs,once the lens is removed.if the lights are in the trunk tailgate and there is no screws then with the trunk lid open and you look inside above the area the lights you should see the bulb sockets that you turn a 1/4 turn to remove the socket to replace the bulbs.
Follow
the Steps on how to replace license plate light on your car.
1.
Open the trunk and locate the trunk liner retainer clips.Use the
Phillips head screwdriver to loosen the center plastic screw of the
retainer clip about 1/4 turn, just enough to raise the head of the
screw from the base of the clip. Pull the screw up, and lift the
clip out of the liner. Use a flathead screwdriver to help pry it
out. Remove enough of the clips to allow access to the license plate
light sockets. Pull the liner back.
2.
Remove the emergency trunk release handle by popping off the top
cover of the handle. Use the needle nose pliers to gently squeeze
the prongs on the shaft, while removing the handle.
3.
Unplug the wire harness from the license plate light bulb socket the
release clip on the side of the outlet.Twist the license plate light
bulb socket 1/4 turn counterclockwise, using the needle nose pliers
again. Do not apply too much pressure to the pliers; you may damage
the socket.
4.
Remove the bulb from the socket, and replace it with a new one.
5.
Replace the socket into the socket assembly, and plug the wire
harness back in. Test the bulb by turning on the lights of the
Corolla, then turn them off again.
6.
Replace the trunk emergency release handle, and replace the hood
liner and the retainer clips. Remove the old bulb and tools, and
close the trunk.
330 views
Usually answered in minutes!
×