67 Riviera Serpentine Belt Routing - Riviera Buick Cars & Trucks

there should be a decal under the hood somewhere that shows the belt routing. if its gone you can probably go to the library and find a book of your car that will show the routing and you can either draw a picture or take a photo of it.

Fig. Accessory serpentine belt routing-4.3L, 5.0L and 5.7L engines without A/C




Fig. Accessory serpentine belt routing-4.3L, 5.0L and 5.7L engines with A/C

Fig. Accessory serpentine belt routing-6.5L Diesel engines

Fig. Accessory serpentine belt routing-6.6L Diesel engines

Hope this helps (remember to rate this answer).

this vehicle should have a spring loaded tensioning pulley that you use a wrench or breaker bar in a square slot in pulley's arm. It should be marked on a diagram somewhere in the engine compartment showing the belt routing...

Fig. Serpentine accessory drive belt routing-3.0L (VIN U) engine


Fig. Serpentine accessory drive belt routing-3.0L (VIN S) engine


Fig. Serpentine accessory drive belt routing-Ford 3.0L (VIN U) engines


Fig. Serpentine accessory drive belt routing-Ford 3.0L (VIN S) engine


Fig. Serpentine accessory drive belt routing-Ford 3.4L SHO engine


Fig. Water pump drive belt routing-Ford 3.4L SHO engine
i wasnt sure what engine you had hope this helps good luck

You didn't list your motor size so please pick the applicable diagram:


Accessory serpentine belt routing—4.8L, 5.3L & 6.0L engines


Accessory serpentine belt routing—5.7L engines with A/C


Accessory serpentine belt routing—5.7L engines without A/C


Accessory serpentine belt routing—6.5L Diesel engines


Accessory serpentine belt routing—7.4L engines


Accessory serpentine belt routing—8.1L engines

look around under the hood , on the underside of the hood, sometimes the belt routing diagram is on a sticker also check a Chiltons Manual sold at auto pARTS STOReS or on the web

You are correct. If you remove the washer and coolant reservoir you gain quite a bit of room, but the belt routing makes it mandatory you remove the top front motor mount to install a new belt. Just support the front of the motor with a floor jack and remove the upper mounting bolts.

Generally there is a sticker under the hood, showing belt routing. If not, get a cheap (usually under $20) manual... not only will you learn belt routing, but tips on tensioner adjustment, necessary to replace belt. Even a cheap manual includes lots of stuff you may need to know in the future!