My electric antenna on my 95 jeep will not go up.

It sounds like there may be an issue with the electrical system of your 2011 Jeep Liberty after the heater core replacement. Here are some things you can check to diagnose the problem:

1. Wiring: Make sure all the wiring has been properly reconnected and check for any loose or damaged wires.
2. Fuses: Check the fuses to make sure they have not blown as a result of the electrical issue.
3. Blower motor: If the blower motor is not functioning properly, it may be causing the issue with the blower speed. Check the motor for any damage or signs of wear and replace if necessary.
4. Electrical control module: The electrical control module is responsible for controlling the various electrical components in your vehicle. If it is not functioning properly, it may be causing the issues with the blower and the radio.
5. Radio: If the radio is only working on satellite, there may be an issue with the antenna or the connection to the antenna. Check the antenna and the connection to make sure everything is properly connected.

it is a unit not repairable

the Fsm covers that. "factory service manual" posted like 1000 times here.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service
1996
audio chapter
page 10, clear step by step instructions

8F-10
BINGO,

same as allcars
unbolt it, remove it.
is car in USA,
some cars have electric motor up/down antennas.
if USA ,the manual is free to read, posted over 300 times
search much.?
2000 Grand Cherokee, is name, WJ jeep
see AUDIO chapter
here ,its there, under WJ


http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Easy peasy...under where the antenna mounts should be the motor if its retractable and electrical connector..d/c the connector and remove the bracket, antenna should pull out - reverse for installation!

It's not necesary, just the center bezel for take off the radio cover; I suggest check your service manual: ZJ-Secc-8F-Audio-Systems

Hope help with you (remember rated this).

You need review the Jeep XJ Repair Manual:
- Section-8WL-Wiring-Diagrams-General-Information-95XJ8WL
- Section-8WR-Wiring-Diagrams-95XJ8WR

Hope helped with this (remember rated this help) Good luck.

this is how we did it for my Dads jeep his was a 98 so it should apply. let me know if it doesnt and i'll go break it down on my friends jeep 2000

Unscrew the antenna and the base flat base nut. Unfasten the mud guard in the wheel well enough to pull it aside and reach up to the antennae. Remove the kick panel to find where the cable enters the jeep.

From the factory wiring there will be a red/white wire with a constant 12v and an ignition switched 12v wire which is red/gray. Hook those to corresponding wires on the aftermarket wiring harness. You may have the constant and switched wires backwards. Also the antenna trigger wire (usually blue on aftermarket radios) should be hooked up to the green/red wire on the factory harness.

For a complete wiring schematic check out www.the12volt.com

Try looking in fuse/relay power distribution box under hood . Should be labeled underside of cover.