SOURCE: were is oil filter located on chevy malibu 2008
it is behind the oil dip stick on the top of the engine.
this should be what they call a cartridge filter you will need a 1 1/4" socket. there is what looks like a big plastic nut. Remove the plastic nut and pull the filter out. if you do not have an 1 1/4" socket you can go to any parts store and by this tool.
SOURCE: where is the fuel pump located on a chevy malibu
It's located in the gas tank and to replace it, your going to have to drop the gas tank.
Thank you for using fixya and if you are going to replace the fuel pump your self. Make sure you also replace the wire harness from the frame to the fuel pump.
SOURCE: where the fuel filter is located on chevy malibu
along the frame rail, will need special tools that you can get at any parts store. Remove gas cap to depressurize the system first. You will still have to get agressive with the line, sometimes u think your going to break it.
SOURCE: Change headlight on 2008 Chevy Malibu
Hi there,
Well first you can please follow the below steps -
1. Make sure the ignition key is in the off position and the headlight switch is off. Release the hood latch.
2. Open the hood and locate the top of the headlight assembly where you intend to change the headlight. If a plastic shroud is present, locate the center bolt and remove it with a ratchet and a socket. Lift the shroud out of the way to access the headlight assembly retaining brackets. Some later models may feature a snap-release shroud requiring no tools to remove.
3. Locate the brackets on the top rear of each side of the headlight assembly. Lift them all the way up to align the hole on the bottom of each bracket to the retaining tabs on the assembly.
4. Pull the assembly forward away from the Malibu, but be careful not to scratch the bumper. There are three guide pins that require unseating. The guide pins are what aim the headlights and it may take some wiggling to get the pins from their seats.
5. Support the assembly with one hand and then reach behind the unit with the other. The low beam bulb is on the outside, the high beam bulb is on the inside. You can also replace the parking light if desired. Locate the wire harness connection. Un-clip the wire harness from the back of the bulb socket. Remove the bulb by turning it counterclockwise 1/3 of a turn to align the release tabs of the ring and the assembly. Wiggle the bulb out of the assembly.
6. Place the latex gloves on your hands before opening the package of the replacement bulb. Oil in our skin can damage the glass bulbs of halogen headlights.
7. Carefully insert the new bulb into the ring and then align the tabs of the ring to the tabs of the headlight assembly. Push inward and then twist clockwise 1/3 of a turn to lock the bulb in place. Reattach the wire harness. Rest the headlight assembly inside its cavity and test the operation of the headlight before securing the headlight assembly in place. Be sure to turn the lights and ignition back off.
8. Align the three guide pins to their seats and push the assembly back into them gently until they snap into place. Replace the retaining brackets by pushing them downward to lock into place. Replace shroud, if applicable. Remove the tools and old bulb and close the hood. Post comments for further help or information......
Good Luck!!
7,103 views
Usually answered in minutes!
Under car in front of the fuel tank is the in line filter. First remove gas cap to stop tank pressure. One end of filter you use two wrenches the other end has a plastic slider ring,don't brake the ring! Slide the ring toward the filter and squese with fingers and pull apart by hand. You will have full leakage when you crack the lines,wear safety glasses and be careful.
×