SOURCE: map sensor pin arrangement dodge cavan 2003
Hello, here is a picture of the connector and wiring.
MANIFOLD ABSOLUTE PRESSURE SENSOR (GAS) - BLACK 3 WAY
CAV
CIRCUIT
FUNCTION
1
K1 18VT/BR (3.3L/3.8L)
MANIFOLD ABSOLUTE PRESSURE SENSOR SIGNAL
1
K1 18VT/BR (2.4L)
MAP SIGNAL
2
K900 18DB/DG
SENSOR GROUND
3
F855 18PK/YL
5 VOLT SUPPLY
Pink/Yellow is #3, Blue is #2, and Purple is #1. Your colors may appear slightly different
Save your money, the chip is a ohm resistor at Radio Shack for under $2.00. It splices in to you IAT wire harness located at the intake tube between the air filter housing and throttle body.
Problem with this system is, that you can not adjust anything and have to run a constant 91 octane just to make sure you do not have a Detonation. The ECM will catch the Detonation from the knock sensor and compensate for it by retarding the timing which in turn lose of HP till next start up.
If you like and don't mind the check engine light on once and awhile, you can do the same by just disconnecting the IAT wire harness which give the ECM a 0 resistance thinking it's -20 out side and turn the timing up and lengths the injector pules.
When i was running a Nitro in the Toy before i sold it, i had installed a 10K ohm Potentiometer which you can buy at radio shack for under $5.00 i believe, I just spliced it in to the IAC wire harness so if i wanted to play with the Nitro I'ld turn the resistor up making the engine think it's 185 degrees F and would ****** the timing so i would not hurt the engine. But if i wanted to get more timing i would just turn the knob to drop the resistance to get more time since the engine thinks it's -20 out side.
Hope this helps. Keep me posted if you need more info. Best thing is to do a dyno tune and you can change everything right down to the Shift points.
SOURCE: MAP or MAF Sensor Diagram for 2005 Town&Country Touring Van 3.8l.
Yes it has a sensor and they are color coded however I don't think it's called a maf or map sensor that’s a GM name, there would be three wires on it on ground one 5 volts reference and one for connection to the computer to tell the computer how much air flow there is, and the reading would be from 1.5 volts to 4 volts.
SOURCE: Pontiac Bonneville 2003 oil pressure 120/// and maf sensor code
Replace oil pressure sensor. What is the code?
528 views
Usually answered in minutes!
×