The hazard light button actually cracked off the unit. If I push it back in, they work, push to turn them off.They blink all around, so it isn't a bad bulb. I could live with this,,,,but there are no turn signals. No arrows on dash, but they light when hazard button is forced to work. Is it the multifunction switch gone bad?

The service and repair manual with diagram will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com/

Hi BJ:
Interesting...........

- Hazard lights work when ignition is turned OFF.
- Signal lights Don't work when ignition is turned off.
- Is it possible that the Right signal bulb is burned out?
- I'd be checking the functions of all of the bulbs.
How did this problem start?
Please reply as a COMMENT to this post.
Cheers.

The blinker relay is getting worn out. It's right behind the hazard lights switch. Pull off the black trim around the radio, hazard, ets, and the relay is write there. Next time the blinkers stop working hit the hazard button or hit the trim just above the hazard lights button. Mines been doing it off and on and I just hit the trim above the hazard button and they start blinking again. Never have time or remember to get a new relay.

Have you replaced the relay because there's one of them as well with the flasher unit. I've been having a problem with my hazards not working but turn signals work fine. Maybe the arm on your steering column might be on its way out because they do get used alot.

there should be a button on the right side of the steering colume that you just push in towards the colume to turn the hazards on and pull the button out to turn them off.

Sounds like your flasher relay is broken. A lot of people think that because their hazard flashers work that everything is OK, this isn't so. Hazard flashers are on a seperate system, and as such they have their own relay.
You will need to find where your indicator relay is located and replace it with the correct type.

If the hazard button is stuck, turn signals wont work. If you havent done it, try wiggling the button, press it hard and release it to see if it springs back to position. If that doesnt work, try forcing it back with a precision flat screwdriver, taking care not to mar the fascia. If this doesnt work, you will ,unfortunately, have to take down the radio/ head unit fascia, where the button is installed. Look elsewhere on Fixya for instructions to disassemble an Accord dashboard fascia, it isn't easy.

REMOVE HAZARD FUSE IT WILL TURN OFF FLASHER UNTIL YOU FIX HAZARD BUTTON.
YOU GOING HAVE TO REMOVE SPEEDOMETER AND TACH CLUSTER TO GET TO HAZARD SWITCH.TURN OFF RADIO FIRST BEFORE REMOVING NEGATIVE BATTERY CABLE BECAUSE YOU WILL DISABLE AIRBAGS WHILE WORKING AROUND STEERING WHEEL AND DASH AREA. WAIT 20 MINUTES BEFORE WORKING AROUND DASH AREA AFTER DISCONNECTING NEGATIVE BATTERY CABLE.

it sounds like the relay has gone for your hazard lights, when you press the button to turn them on, it will disconect the power to the main indicators hence wont work when hazards pused in, try locating either the hazard flasher unit, or the relay , have you checked the fuses?

I had the same problem twice before. Solved it the same way both times. In my case it was the Hazard switch at the top of the steering column. It was stuck. I knew it was that because the signal lights had been functioning perfectly until I parked my car alongside the road with the hazard lights on to do some nighttime fishing and sip a little white lightnin'. (just kiddin' about the white lightnin')

When I got back in my car to go, I turned off the hazard lights but I had no turn signal lights! So I kept pushing that hazard button up and down for about 30 times with my left turn signal arm down until it started working again. So after having this happen to me twice, I learned a valuable lesson: Don't ever use hazard signals in this car.