Question about 1999 Chevrolet Silverado 1500

1 Answer

98 chevy k1500 cruse control

Cruse control just stopped working fuses seem to be ok what else could be the problem

Posted by on

  • 2 more comments 
  • phillipstrin Mar 13, 2009

    I have a 99 chevy c/k truck and my cruse control just stopped working. The fuse's are good. I was told by a chevy dealership that it is the brake swtich. where is the brake switch and how hard is it to replace?



    Phil

  • Anonymous Mar 26, 2014

    2007 vw touareg ruse control stoped working is there a fuse ?

  • Anonymous Mar 26, 2014

    2007 vw touareg is thera fuse for the cruse control?

  • Daniel Day
    Daniel Day Sep 20, 2018

    To Louie Role: Daniel Day, concerning the cruse control - thank you so much for all of the possible solutions.

    Back 40+ years I street raced, etc and did most of my own work. These days, even with my 2004, it is like reading Greek to know where anything is.

    You mentioned "most likely": vacuum line to the Actuator, diaphragm, control valve. I don't even know where that is. I imaging on the engine close to the throttle linkage? Am I close? Where could I go to get a picture or diagram of that so I know what I should be looking at?

    I cannot thank you enough for your taking the time to help me, Your awesome!

    Thanks again, Daniel

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi,

Appreciate the "Ask Me".

To my knowledge, Cruise Control would be relatively difficult to diagnose without a scan tool attached to the control module to read the error codes. Additionally, car versions in my country seldom have such a device since our roads are narrower and travel distance is not that great.

Though most known causes are:

  • the connector to the module;
  • loose brake pedal/switch;
  • loose clutch pedal/switch (for manual transmission);
  • vacuum line to actuator (most likely), vacuum actuator, diaphragm, control valve.
Other possible components to check are:
  • the control module itself (bolted to the firewall);
  • control cable or linkage;
  • speedometer sensor;
  • steering wheel controls switches;
  • throttle position sensor.
As posted above, quite a number of possibilities. Any other indications, speedometer OK; abnormal throttle responses; abnormal idling, brake light always ON, slack in the accelerator/gas pedal? Was it cutting in/out before? Was there any recent repair work done on the engine before the cruise control cut out?

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Posted on Aug 04, 2008

  • Daniel Day
    Daniel Day Sep 20, 2018

    Louie, thanks so very much for this wealth of information. I do not know if you received more questions from me that i sent to you, new to the site so not sure what/where to post thanks and more questions. I suppose this is it.
    Where is the vacuum line to actuator (most likely), vacuum actuator, diaphragm, control valve? Up close the top of the engine? I will look around. And WILL find it. I do not like to let things beat me haha. Thanks again for all the help!!!...Daniel

×

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Chevy Tahoe, cruse control stopped working briefly at 50,000 miles. Yesterday at 204,800 miles it stopped working again, then worked for 10 miles and stopped working again.


Check the adjustment and condition of the brake light switch located above the brake pedal. If it's out of adjustment, it will shut down the cruise.

Sep 20, 2018 | Cars & Trucks

2 Answers

How to fix Cruise Control


The most common problem on this vehicle is the sensor right on the master brake cylinder the seal goes out and brake fluid gets right in the sensor ruining it that is the most common problem lete no if it helps

Sep 22, 2014 | 2001 Ford Windstar

1 Answer

Cruse control does not work


It sounds like a connection to your cruise control may have come loose and was not intentionally done by the mechcanic. I would take it back and ask him or her to take a good look again at the work he had performed and maybe it will show up in front of his face plain as day

Jan 23, 2010 | 2002 Oldsmobile Intrigue

1 Answer

1994 GMC P/U's cruse control no longer works. Appears no power. Checked fuses in panel but no fuse by name of ''cruse'' and all fuses OK. Need diagram or schematic and/or help troubleshooting.


Does your turn signals, high headlight beam work? Also, does the AC function through the dash vents and not the defrost vents?

My cruise control quit and I found it was the vacuum lines running to the servo.

Aug 28, 2009 | 1994 GMC Safari

2 Answers

Brake lightswill not work aven after changing Bulbs. What could be the problem?


Need to check the brake light switch. ok down by the brake pedal there is a switch that tells the lights to turn on when you push it. almost always easy to fix and you can buy a switch aftermarket for around $10 bucks. If you have cruse control a good way to check the switch is to run the cruse con and try to get it to stop crusing by pushing the brake pedal if it keeps going thats your problem. hope this helps

Aug 20, 2009 | 1995 Pontiac Sunfire

1 Answer

1996 chevy caprice wiring diagram for cruse control


Are you trying to instll he cruse system in another car? BAD IDEA Are you trying to fix it in your car? first cause of fail is the third stop ligh blow

Jul 15, 2008 | 1996 Chevrolet Caprice

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

1,215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...