- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The rod bearing cap bolt torque specifications for the 3.0L V6 engine in a 2000 Ford Ranger XLT 4x4 with a manual transmission are as follows:
Step 1: Tighten the bolts to 15 foot-pounds of torque.
Step 2: Tighten the bolts to 30 foot-pounds of torque.
Step 3: Tighten the bolts an additional 90 degrees (1/4 turn) using a torque angle gauge.
It's important to follow the torque specifications and sequence in the manufacturer's service manual to ensure proper tightening and prevent damage to the engine.
www.fordforumsonline.com > Ford Tech Forums > Engine & Drivetrain
May 7, 2010 - 2 posts - ā2 authors
ISO torque specs for the intake & plenum for a 98 Windstar...3.8 with the ... Our community is here to help you with any questions you have related to your Ford. ... Lower Intake Manifold to Cylinder Head Bolt 8-12 - (71-106).
its not very hard at all. once you get the heads off just make sure you follow the proper sequence to tighten the bolts. always remember to tighten from the center bolts out to the end bolts so the heads seat flat and even. and make sure you have the proper torque specs for those head bolts. 1) hand tighten. 2) torque to half of the OEM spec. 3) full torque spec. all of this takes a while to do so be patient.
Torque sequence ------------ front ' 6 4 2 8 ' ' 5 1 3 7 ' ------------ Step 1: torque in sequence to 59 Ft/Lbs Step 2: loosen all bolts in sequence (1) full turn Step 3: torque in sequence to 40 Ft/Lbs Step 4: torque in sequence to 73 Ft/Lbs recheck final torque in sequence
Torque Specifications for Ford 4.2L-256ci-V6 These bolts are torque and turn procedure! STEP 1: 14 FtLbsSTEP 2: 29 FtLbsSTEP 3: 36 FtLbsSTEP 4: LONG Bolts Loosen 3 Turns - re-torque to 33FtLbsSTEP 4: SHORT Bolts Loosen 3 Turns - re-torque to 19FtLbsSTEP 5: ALL Bolts +180deg turn
heres the torque specs and the way to tighten the head bolts for your 1998 toyota sienna, hope this helps,
12 point bolts step 1- 40 ft lbs
step 2- additional 90 degrees
recessed bolt 13 ftlbs
×