Where is the alarm sytem control module located and how do i program new remote transmitters on a 2004 hyundai santa fe. is there a picture of what the contrl module looks like.

SOURCE: how to change spark plugs on hyundai 2004 2.4L

Remove the plastic cover that goes over the engine (the one with the Hyundai logo).
At this point, you will see the cables that goe to each fo the spark plugs.
Noting their position, remove them.
The spark plugs are ready to be removed, turn counterclockwise and replace with manufacturer recomended ones.

SOURCE: how to program 2004 Hyundai Santa Fe Keyless Entry

I have a 2002 Hyundai Santa Fe and just completed adding keyless remore. The control module is the large black box behind and below the fuse box next to the hood release. 'Set' and 'off' are written small and in yellow on the side of the box closest to the steering column, and were obscured by wires coming out of the fuse box. There was a sticker over the switch that had to be pierced to get to the small switch. I used a small pick to move the switch as it is difficult to get your fingers in there. Turned ignition switch two clicks to 'Acc' location and waited 5 seconds; some instructions I found said move to 'on' location but didn't work for me; then moved switch to 'set'; pushed remote lock button; set switch to 'off'; turned off ignition and tested. Most difficult part was finding switch.

Ed

• 479 Answers
• Posted on Apr 21, 2009

SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe

If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.

Hope this is of some help.
Ed

Marvin

• 85242 Answers
• Posted on May 22, 2009

SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE

This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.

SOURCE: Change serpentine belt 2004 Hyundai Santa Fe

it uses a spring loaded tensioner.use a breaker bar to rotate the tension and it should just come off.if u need a pic or anything else to do it let me know,