Question about 1988 Nissan 200SX

1 Answer

1988 Nissan Bluebird 1.8 problem.\r\nWhen car in motion and go over 2 on revvs will not return even when gearing in neutral, stays on 2000 revvs. Will not return until car stationary eg at lights. Starts up fine, ticks over fine at just under 1. When stationary can be revved and will return to tickover no problem.

Posted by on

  • myerslouise9 Mar 21, 2011

    Thanks for help, have tried link but unable to get further not able to click on any links.

  • myerslouise9 Mar 21, 2011

    Could you post solution here please many thanks.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 6,360 Answers

I think you should buy repair manual first for your vehicle after that it will be easy for you to solve the problem. Check the link may be you will get something useful here 1988 Nissan 200SX

Posted on Dec 14, 2017

Ad

5 Suggested Answers

CMV9

Cameron Viseth

  • 594 Answers

SOURCE: Nissan Maxima QX 1995cc 1999 - Engine hesitation and sometimes cutting out - intermittant problem

what do you mean by hunting?

Posted on Aug 10, 2008

Ad

Anonymous

  • 68 Answers

SOURCE: Engine revving itself

I would guess the idle control/stepper motor.

I think you could pic one up cheap at rockauto or ebay

Posted on Feb 12, 2009

Anonymous

  • 7 Answers

SOURCE: My car engin dose not start,it is 1993 nissan bluebird ARX?

This def sounds like a fule pump issue ...it should be located in the gas tank its self although i would check the fuses first before getting into the tank.
If this is in a 240sx the way into the tank is through the trunk.Lift the carpet and you will see on the mid right side a small 6-8" lid with some wires going into it. Unscrew that and your on your way in.
If you do pull out the pump just be careful handling it as to not break the sensor unit attached to the pump.

Posted on Aug 19, 2009

Anonymous

  • 1 Answer

SOURCE: car over revving when stood

Try the gasket between the carburettor or the vacuum pipes may be pitted or holed, sounds like its letting air in causing the engine to rev.
Hope this helps.

Posted on Nov 19, 2009

goye

  • 84 Answers

SOURCE: FIAT PUNTO. Ticking for short period following start up

Definitely change your oil every 3 months or 3000 miles. After you change it add a half cup of Lucas engine oil suppliment when the engine is hot.
If if goes away you know it's cam or lifter issue. If it doesn't the ticking you hear may simply be your fuel system.

Posted on Jan 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pls my nissan bluebird 2005 model jerks when fired on motion n also turns off engine while on motion, please help. Thanks


Wiring, schematic,
electrical diagrams, fuse diag, error codes etc are basic contents of these online books they sell here on this website www.reliable-store.com I have attached. Must check it out

Mar 14, 2018 | Nissan Cars & Trucks

1 Answer

The steering of my car vibrates with the car stopped. Some body help to solve this problem? Its make me crazy. With the car stopped (N neutral position) when I speed (over a thousand turns) and loose the...


Probably the wrong place to be asking this question. If you don't have knowledge of the workings of any vehicle, then you need to find repair shop. If you have friend that works in repair shop, ask him. It sounds to me that you have lose fitting or knuckle where the rod attaches to gear box. It definitely needs to be check as soon as possible before you lose your steering.

Feb 04, 2015 | Nissan Cars & Trucks

2 Answers

The transmission won't move in forward but will in reverse?


get the OBD codes read as will point you in the direction of the fault

Oct 15, 2014 | 2007 Hyundai Elantra Limited Sedan

1 Answer

RPM rising and falling on Nissan bluebird fuel and ignition seems ok


1998 Nissan Maxima bluebird?
did not bluebird end in 1994?
ill answers for 1998 USA, if car is a JDM , well that be different

you have idle surge, (aka hunt)
the ECU controls idle at all times.
there are 10 or 2o things that can cause surge.
many tests. are you up for tests and buying tools, or just want a wild guess>?
1: EGR mains stuck open.
2: ISC stick (electric idle valve)
3: TPS switch ,not closed, at idle (that kills idle controls dead
4: lean AFR. and ISC has lost control or makes it hunt.
5: intake air leaks.
6: ECU in limphome. the USA cars (no location stated, bad)
all usa cars have OBD2 this year, ever use a $7 scan tool yet?
CEL stuck on running. never pulled the DTC errors?

ill stop here, there are 10 more. at least.

Oct 09, 2013 | 1998 Nissan Maxima

1 Answer

My bluebird stops on motion and has since couldn't


please explain in more detail as iam a slightly cnfused as to the motive of this question

May 10, 2012 | 2002 Nissan Bluebird

1 Answer

Have just bought a 1988 Nissan Bluebird, need to know if the engine and gear box oil are seperate if so where do you change the gear box oil?


there no automotive engines that share same oil with transmission
on your gear box there should be two plugs one in about middle and one near bottom the bottom one is your drain and the top one is your fill

Jan 23, 2011 | Nissan 200SX Cars & Trucks

2 Answers

Getting a strong vibration at 70mph plus. seems


un balanced tire or bad tire have a tire shop look to c if a tire has thrown a belt

Mar 25, 2010 | 1988 Nissan 300ZX

1 Answer

1989 nissan pathfinder transmission issure


time for a new/rebuilt computer for your 1 gear issue sounds like a few stripped gears or synchronization issue in the transmission you need to take your truck to a transmission repair shop get the sensor checked and sync bar checked for any broken pieces and metal shavings may also need to replace you slave cylinder make sure it goes in and out have someone sit in car and press clutch in you get under the front and look before clutch assembly for little black bar that is going in and out

Apr 22, 2009 | 1988 Nissan Pathfinder

2 Answers

Automatic transmission goes into Park or Neutral ONLY


Check fluid level? Have you ever had the transmission serviced? Could be toast...?

Sep 29, 2017 | 1988 Nissan Pulsar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...