Rotate the lock cylinder to the lock position. On tilt columns, remove upper extension shround by squeezing at 6 and 10 o'clock and popping free of the retainer plate at 3 o'clock.
Remove 2 shroud halves by removing the screws. Disconnect the electrical connector from the ignition switch. Drill out the 2 break-off bolt heads that hold the switch to the lock cylinder using a 1/8" drill bit.
Remove bolts (may have to use a screw extractor). Disengage ignition switch from actuator pin and remove switch.
To Install:
Rotate the key to the run position. Install switch by aligning holes on switch base with hole in the cylinder housing. You may have to move it a little to get the actuator pin to line up.
Install new break-off bolts untill the heads shear off. Connect electrical connector to switch.Then reverse the removal procedure to complete.
810 views
Usually answered in minutes!
×