The maintence light, is it the same as a check engine light? If it is go to a auto zone parts store and get the codes read and they will reset it after reading codes, and it wont cost anything, its free
Make sure the mileage setting is on odometer, turn off the key, then hold the reset button in and turn on the key [ don't start motor ] after a few seconds the dislpay will show just dashes [ ------ ] these will disapear from left to right then blink and the mileage will repear [ it may also beep ]. turn the key off, the reset should be complete.
SOURCE: Reset the maintenance required light on my 2008 toyota corolla
OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..
SOURCE: What are lubrication requirements for 2008 Toyota Avalon XLS?
Your Avalon uses 5-30 oil, 6qt with filter. Trans is Toyota's WS(world standard) ATF(there is no dipstick) There are no grease fittings on the car.
All the maintenance schedules are listed in the owners manual per mileage.
665 views
Usually answered in minutes!
×