1992 Buick LeSabre Logo
Anonymous Posted on Jul 31, 2008

Buick lesabre no start

"Need help with 92 buick lesabre 3800. Eng cranks but will not start. I spray ether into air cleaner & eng will start, run & only continue running while spraying ether into air cleaner. By keeping engine running 2 to 3 mins it will run on its own and idles fine after warm up. By snapping throttle engine bogs and hesitates. I let eng cool off and will crank but no start without ether. I have replaced the fuel pump twice, strainer, fuel filter, inpected all fuel& return lines, replced cam sensor, crank sensor, ign module, all three coils, map sensor, idle air control valve, computer, pcv valve. TPS shows .38 volts at idle, over .4 at full throttle. I have spark tested on all coils - passed.Did a noid injector test - passed. Fuel pressure at 45psi fuel pressure increases slightly when vacum hose is removed from pressure regulator. In spected wiring harness & all ground connections only thing left to check is vac leak at intake or plenum. Please help, desperate!"

  • Anonymous Mar 21, 2014

    Fuel problem?

×

3 Answers

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Champion:

An expert who has answered 200 questions.

  • Expert 255 Answers
  • Posted on Aug 18, 2008
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Champion:

An expert who has answered 200 questions.

Joined: Jul 27, 2008
Answers
255
Questions
3
Helped
151630
Points
647

Hi you have replaced allmost everything ,(try fuel pump relay)

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 5 Answers
  • Posted on Jun 12, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jun 12, 2009
Answers
5
Questions
1
Helped
4360
Points
11

You have eliminated most possiblites so you have eliminated me spending all that money i figured out because of rotten egg smell i have determined my cat converter is plugged so i am going to cut it out and replace if nessasary if engine no longer bogs my problem is exactly like yours but mine is intermintent but now it has become extremly bad and its running to rich burning your eyes rich so i hope this solution has helped you in any way Thank you

Ad
A

Anonymous

Were is fuel pump relay

1 Related Answer

Anonymous

  • 321 Answers
  • Posted on Jul 31, 2008

SOURCE: buick lesabre nightmare

Need to get a scan tool and look at the data stream while it is running for alot more info.Also any trouble codes.Sounds like initially,the engine isn't getting any fuel.I would have a pressure gauge connected to the fuel rail on the engine,so i could monitor the fuel pressure while all this is going on.Items to look at on the data stream would be timing,what timing is the PCM commanding for the engine.Also,have you checked for continuos power feed to the coils during this no start condition,and fire at the plugs while cranking.You could possibly still have spark,but maybe it is extremely weak?I have seen bad ignition switches cause weird problems before too.Many things power up through the ignition switch,just a thought.Have also seen bad PCM's cause strange problems..38 volts is a little on the low side for GM.Usually see those at,at least .50 and up,and rise steadily while pressing the throttle,up to just under 5.0 volts.Potentiometer with 5 volt supply.Vacuum leak can be checked with engine running at a steady idle speed,spray brake cleaner all around the intake manifold and listen for engine speed change.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My 2010 buick 3.8 ltr super charged eng shuts off while im driving why

Remove the air cleaner intake tube and buy some throttle body cleaner spray on a rag open throttle manually and clean the most carbon you can from around the flap.
If you remove the throttle body and clean it outside of vehicle it will be much better.
If the intake is plastic then you will have rubber o ring behind throttle body no need to replace it is reusable.
If the intake is aluminum then it will have paper gasket and the possibilitys of breaking it is high. So if you decide to remove make sure someone has gasket in stock whether its dealer or local autoparts.

Idle air control is built in to throttle body it gets excessive carbon deposits if you use low octane fuel like (87) when it fills with carbon it restricts the air amount at closed throttle and cause car to shut off.
Email me at [email protected] if you have more questions.
0helpful
1answer

2004 Buick lesabre was bucking hard after a complete stop and go. Replaced transmission speed Senor and changed transmission oil and filter. Now when I press the gas it wont go forward or reverse, but the...

what color was the fluid, does it rev up & not move is ther a check eng light on & is the dipstick full with eng running? if the filter fell off in pan it will **** air you might try over filling it by 2 qts to prove this. note this is computer controled all except reverse if no reverse its internal in trans. is there any chance an axle poped out if it holds in park that is ok & not a factor.
0helpful
1answer

1998 Buick LeSabre. This car started to act up while driving home, and when I went to leave again it would not start. Family thinks the engines no good, I think It could be a fuse or a computer? Could...

Sounds like to me your Fuel Pump might have quit on you. You would need to check Fuel Pressure with the proper testing equipment but a fast way if you are CAREFUL spray a little bit of carb cleaner while someone is cranking the car into the boot where the air filter is , if this VEHICLE has a Mass Air Flow sensor AVOID spraying into it or you will damage it. find another area to add this spray and see if it starts up.
1helpful
1answer

My 1992 buick LeSabre will not started.Lights and horn works.Battery is fully charged.Won't turn over,and no sounds coming from eng.conpartment.

The LeSabre's starters are known for going bad. I would replace the starter and I am sure that will fix your problem. Hope that helps!
1helpful
1answer

Buick 3800 wont start help

Change plugs check wires for correct connection. Check pcv for vacuumn leaks. Starter fluid on mass air flow meter may damage it.
0helpful
1answer

Changed the Engine and not running

if it cranks check the fuel pump make sure its turning on
1helpful
1answer

2001 Buick Lesabre

Do you have check engine light on???if so scan it OBD 2 yue$$ding isn't the way to go,if you don't have a check engine light on then perhaps coil pack!!! coils do run intermittent some times! and not trip the eng light on !!!!this would be a great place to start.Hope this helps
0helpful
5answers

Buick lesabre nightmare

Need to get a scan tool and look at the data stream while it is running for alot more info.Also any trouble codes.Sounds like initially,the engine isn't getting any fuel.I would have a pressure gauge connected to the fuel rail on the engine,so i could monitor the fuel pressure while all this is going on.Items to look at on the data stream would be timing,what timing is the PCM commanding for the engine.Also,have you checked for continuos power feed to the coils during this no start condition,and fire at the plugs while cranking.You could possibly still have spark,but maybe it is extremely weak?I have seen bad ignition switches cause weird problems before too.Many things power up through the ignition switch,just a thought.Have also seen bad PCM's cause strange problems..38 volts is a little on the low side for GM.Usually see those at,at least .50 and up,and rise steadily while pressing the throttle,up to just under 5.0 volts.Potentiometer with 5 volt supply.Vacuum leak can be checked with engine running at a steady idle speed,spray brake cleaner all around the intake manifold and listen for engine speed change.
Not finding what you are looking for?

880 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...