At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Remove inner door handle and arm rest if applicable, with a flat screw driver or chisel leaver door cover away so as to gain access, undo the screws on old handle,remove rods ,then remove handle fit ,new handle .mark rods with paint so they go back in the same place.
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls.
This is extremely common! The micro-switch inside the glass hatch release is faulty, telling the door that it is partially depressed, thus shutting down opening for safety reasons. You can verify this by opening the glass hatch (there is a access panel at the bottom of the door on the inside), removing the trim cover from behind the glass handle (two philips screws and one plastic push in fastener), then unplugging the glass handle. Your door will now function normally, but without glass opening ability until you replace the handle. The handle only takes a few 10mm nuts to remove and can be changed in a few minutes. It retails for around $35 from your dealer.
Hi. While looking into your question I came across another posting of the same question for a 2004 Mitsubishi Endeavor and I believe it could help you. I put it in a link below. The instruction are basically the same. I hope this helps. Let me know if I can be of anymore assistance. 2004 Mitsubishi Endeavor Headlight Replacement
×