I have 2006 grand prix and the bright lights wont come on. I move the blinker lever forward and the low beams stay on but i get the blue bright light on the dash, checked fuses all seem to be okay

Recheck your connections.

It is one of two things:
1. The turn indicator switch is bad if it is a combo switch that has the dimmer in it for the headlights
2. The clock spring in the steering column.

Sounds like you need a new multi function switch.

it is usually the lever that the light switch is on,you normally push it forward or pull it back to dim the lights.....cheers.

Hi, the problem can be the relay or the body control module. The thing to do is pull the low beam relay out of the relay box under the hood and swap it wil the high beam relay. If the low beams start working instead of the low beams, buy another relay for the high beams. If there is no change, pull the relay out again and interrogate the relay socket with a 12 volt test light or voltmeter. Connect your test light clip to chassis ground and probe the relay socket. There should be 2 hot terminals in the socket. If not, there is a problem with the fuse box. If you get these 2 hot terminals, move your test light clip to battery positive and probe the other 2 terminals in the socket. With the headlight switch off, there should be one terminal that lights the test light dimly. If not, there is a problem with the wire from the relay to the headlights. If this is OK, next turn the headlights on (low beam setting) and probe the socket again. There should now be 2 terminals that light the test light. If not, there is a problem with the wiring from the body control module, the module itself, or the beam control switch. If you get to this point, you will need to check the signals AT the BCM to determine if the BCM is to blame of the switch. Please get back to me for these additional steps, if you get stuck here.

More than likely, the dimmer switch - lever on side of steering wheel to activate high beams is shorted or head light switch itself is bad.

does that car have ground lights or fog lights it may not be your high beams coming on it may be your regular lights do you manually turn your high beams on or do they come on on there own

my friend ! is both beam wont work on low? if yes then check fues other wise some time its burn .so check it throlly ur car beams ....some time lights assambly have problem .so check that as well.
hope u ll get the soloution ....tc

Either the low beam head light bulbs have went out,or the dimmer switch has gone out.

Yes it's the mutifunction switch it needs to be replaced it's the one for the blinker and head lights but if the low beams are going out it's the light switch itself, also expanded ends where the bulb is pluged in could cause this. To fix that you need to remove the connecter and squeeze the conneters together then push them back on. they try it this won't cost you any money, if the stay on your good to go if the go out then if it's the low beams replace the light switch it's not to much $35.00 or so and is easy to replace but would have to tell you how to do that so get back to me and let me know. Thanks for using fixya and please rate me for this free question.