SOURCE: removing front door panel
there will be two bolt that are hidden under your arm rest they will probably be hidden little caps that just pop off most likely a star screwdriver you will need a window handle remover tool if you have power windows dont worry about it but you will also need a door panel clip remover tool or you can get by with a screwdriver covered in a cloth insert at bottem of the door an gently pry untill the door clip start to pop and release you will also need to remove a screw where you open the door from the inside hope you get it off if you break any of the door clips(happens all the time) just take broken one to the dealer or canadian tire or parts jobber hope this helps
SOURCE: Can't figure how to remove right rear door panel on 2001 Pontiac
These are bad about those Cable operated window devices .. If it is bad get on ebay and get one ordered its your best bet.. Just take a flat screwdriver and go around the bottom of the door panel and pop it loose and up the sides .. there might be a hidden screw or two in the middle around the handles.. good luck ..
SOURCE: "Door Ajar" signal on dash panel stays on even when doors are clo
there should be a switch mounted( or more than one) in the door jamb that tells the car when the car door is open...i will probably look like a little plastic plunger...might be broken off or bad internally
SOURCE: 2001 Chevy Impala won't start
If the battery has gone dead, it could cause the security system to go into full lock-up mode. If it has locked up the accessories will work after the battery is charged back up , but the power to the starter will be cut off and it wont turn over. You need to do the 30 minute learn procedure. A GM dealer will print it out for you and you can do it yourself. It's very simple if you follow the procedure exact. hope this helps and good luck.
SOURCE: 1999 Pontiac Montana passenger sliding door stopped working.
Verify the wiring harness which passes under plastic step & carpet at front passenger side. This wiring harness goes from the firewall to the pillar on the right side and some have crimped connectors in them to act as junction between two or more wires (ususlly the 12volt feed), which deteriorate with time, especially with Salt & Water. Then the electric sliding door stops working and even driver the electric seat can loose power.
162 views
Usually answered in minutes!
×