I have a 1991 honda accord. I have the security code for my radio. I had to install a new battery. How do I put the code in and get it to work?

Enter security code, it is in your owners manual within first few pages. It is written in by tech who checked vehicle out before delivery of vehicle. If no manual you will need to bring it in to dealer so they can look up code.

If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

You need the radio security code.

Write down the radio security code and the radio presets on your Honda Accord then disconnect the battery cable. Place the number one piston to TDC and remove the oil pan.

Take out the oil pump chain tensioner and throw it away. Use a 6 mm pin driver to hold the rear balancer shaft, placing the pin driver into the maintenance hole in the lower balancer shaft holder and through the rear balancer shaft.

Loosen and then remove the oil pump sprocket and and take out the oil pump. Clean all the surfaces so they are free from contaminants and debris. Make sure any old gasket is removed from the mating services.

Insert New Oil Pump

Add clean engine oil to the oil pump sprocket mounting bolt for lubrication then install the pump and oil pump sprocket loosely. Take the pin driver away.

Tighten the retaining bolts on the pump then squeeze the new oil chain tensioner and put it in the set clip. Install the oil chain tensioner and remove the set clip.

Reinstall all the components in the reverse order of how you took them out. Wait half an hour -- input the radio security code and the radio presets while you are waiting. Fill the engine with clean oil and wait three more hours before starting your Accord and checking for leaks.

for a stock radio you can only get the security code from a Honda dealer.you will need to show proof of ownership and ID then they will usually give you the code with no problems.Good luck.

radio needs reset again.remove negative battery cable for 5 minutes,reattach.this will reset radio.now turn on radio and enter radio code.

no codes but not just any radio will fit in the dash, contact these folks for advice and help picking the right radio.

http://www.crutchfield.com/S-h7kThgkJtQZ/

if you disconnected the battery you need to put in the security code for it to work again. it has an anti theft device in it. if you dont have the code go to a honda dealership. or check the connection behind the radio its easy to do

To get the radio to work you don't enter the "key code" for your keys. You enter the security code for the radio. Two different numbers. if you make 10 attempts and fail, I believe you have to leave the radio on for either a half hour or an hour before retrying with the correct code. If you can't locate the security code for the radio try this:

The code normally comes on a separate document as does key codes or numbers. You could check the owner's manual to see if it was noted in there. (A bad idea.) Also check for a sticker inside your glove box. If that doesn't work then you need to remove the radio/CD player from the dash to get it's serial number from the back of it. Take that number with your VIN to a Honda dealer and they should be able to get your security code for you. They will likely ask for your driver's license & registration to prove you own the vehicle.

radio code 26523

Pull your radio out and look on the back for your radio serial number and then call Honda with that code and they will give it to you.