What is the green box to the right of the jack in the trunk for? It started to click..

Take it to a qualified GM dealer

It says the tachometer wire is Yellow/Green, you do not have that listed. You will find it in the list below, it is highlighted..

WIRING INFORMATION 2001 Subaru Legacy

WIREWIRE COLOR LOCATION

12V CONSTANT WIRE WHITE Ignition Harness

12V IGNITION WIRE GREEN Ignition Harness

12V ACCESSORY WIRE YELLOW Ignition Harness

STARTER WIRE WHITE/BLACK Ignition Harness

POWER DOOR LOCK (-) WHITE Harness In Driver's Kick Panel

POWER DOOR UNLOCK (-) GREEN/RED Harness In Driver's Kick Panel

PARKING LIGHTS (+) ORANGE At Light Switch

DOOR TRIGGER (-) PINK/BLACK In White Connector Behind Fuse Box

TRUNK TRIGGER (-) YELLOW/BLUE In White Connector Behind Fuse Box

TRUNK RELEASE (5-wire) LT.GREEN/YELLOW At Motor In Tail Gate

FACTORY ALARM ARM (-) Factory remote only

FACTORY ALARM DISARM (-) Factory remote only

TACHOMETER YELLOW/GREEN At Ignition Coil

BRAKE WIRE (+) WHITE/BLACK At Brake Pedal Switch

HORN TRIGGER (-) RED/GREEN Harness At Steering Column

LEFT FRONT WINDOW UP BLUE/RED At Driver Window Motor Inside Door

LEFT FRONT WINDOW DOWN BLUE At Driver Window Motor Inside Door

RIGHT FRONT WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door

RIGHT FRONT WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

LEFT REAR WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door

LEFT REAR WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

RIGHT REAR WINDOW UP BLUE/RED Harness In Driver's Kick From Driver Door
RIGHT REAR WINDOW DOWN BLUE Harness In Driver's Kick From Driver Door

a fuse number 24,,,
The following specifications are for the Ford Contour and Mercury Mystique manufactured throughout 1995-2000.
Fuses Rating Color Circuit Engine bay fuse box 1 80 Black Power supply to main fuse box 2 60 Yellow Radiator fan 3 60 Yellow ABS 4 20 Yellow Daytime running lights 5 30 Light green Fog lamp 6 30 Light green Not used 7 30 Light green ABS 8 30 Light green Air pump 9 20 Light bue PCM module 10 20 Light bue Ignition switch 11 3 Violet PCM memory 12 15 Light bue Horn & hazard flasher 13 15 Light bue Oxygen sensor 14 15 Light bue Fuel pump 15 10 Red Right-hand low beam Passenger compartment fuse box 16 10 Red Left-hand low beam 17 10 Red Right-hand high beam 18 10 Red Left-hand high beam 19 7.5 Brown Heated door mirrors 20 10 Black Windshield wipers 21 30 Light green Electric windows 22 7.5 Brown ABS 23 15 Light bue Reverse lights 24 15 Light bue Brake lights 25 20 Yellow Door locks 26 20 Yellow Main light 27 15 Light bue Cigarette lighter 28 30 Light green Power seats 29 30 Light green Heated rear window 30 7.5 Brown Engine management 31 7.5 Brown Instrument pannel lights 32 7.5 Brown Radio 33 7.5 Brown Front and rear sidelights (left) 34 7.5 Brown Interior lighting & clock 35 7.5 Brown Front and rear sidelights (right) 36 30 Light green Air bag 37 30 Light green Heated blower 38 Unused Relays Color Circuit Location Engine bay fuse box R1 Green Daytime running lights (Canada) R2 Black Radiator fan (high speed) R3 Blue AC cut-out R4 Brown AC clutch R5 Dark green Radiator fan (low speed) R6 Yellow Starter R7 Brown Horns R8 Brown Fuel pump R9 White Low beam headlights R10 White High beam headlights R11 Brown PCM power supply Passenger compartment fuse box R12 White Interior and courtesy lights R13 Yellow Heated rear window R14 Yellow Heated blower R15 Green Windshield wiper motor R16 Black Ignition R17 Unused R18 Black One touch window switch Driver's door R19 Blue Cruise control cut-off Central fuse box bracket R20 Unused R21 Unused R22 White Fog lights Interface module bracket R23 Black Turn signals Steering column R24 White Left-hand flasher Door lock module bracket R25 White Right-hand flasher Door lock module bracket R26 Unused Bulbs / Lights Wattage Type Low beam headlamp 55 9006 Halogen High beam headlamp 55 9005 Halogen Parking / Side light 5 2357A Wedge Front turn signal 21 2357A Bayonet Rear turn signal 21 1157 Bayonet Tail light 21 1157 Bayonet Stop light 21 1157 Bayonet High mount stop light 5 2723 Bayonet Fog/Driving light 55 893 Halogen License plate 5 6418 Festoon Reverse light 21 1156 Bayonet Front sidemarker 5 2357A Wedge Glove box Map light 5 64111 Wedge Dome light 10 6411 Feston Step/Courtesy light Trunk/Cargo area Engine compartment 10 89 Wedge Instrument-general Automatic trans indicator

Hope this helps. It's for a 2004 eclipse remote start.

12volts white/red (40A) + ignition harness
Starter black/red + ignition harness
Second Starter N/A
Ignition green + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory blue/red + ignition harness
Second Accessory blue/black + ignition harness
Keysense blue/red ignition harness
Notes: This wire rests at ground, and goes to an open circuit when the key is inserted into the ignition cylinder.
Power Lock purple - pin 33 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock lt. green/red - pin 34 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor lt. green 5wi pin 19, 28 pin plug below fuses
Unlock Motor green/red 5wi pin 22 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Parking Lights+ green/white + pin 2, 15 pin plug above fuses
Parking Lights- N/A
Hazards green - pin 55 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L) green/blue + pin 8, 15 pin plug above fuses
Turn Signal(R) green/yellow + pin 13, 15 pin plug above fuses
Reverse Light red/blue + pin 9, 43 pin plug in driver kick
Door Trigger see notes - see notes
Notes: The driver door trigger is lt. green, pin 6, in a 15 pin plug above the fuses. The passenger door is lt. green/black in pin 65 at the ETACS ECU. Use both wires and diode isolate each.

The ETACS ECU is attached to the back of the fuse box.
Dome Supervision green/orange - pin 1, 3 pin plug above fuses
Trunk/Hatch Pin red - pin 62 or 37 at ETACS ECU
Notes: It is in pin 62 on the coupes, and in pin 37 on the convertible spyders.

The ETACS ECU is attached to the back of the fuse box.
Hood Pin green/red - pin 24 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Trunk/Hatch Release green/white 5wi pin 32 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Sliding Door N/A
Factory Alarm Arm lt. green/black - pin 42 at ETACS ECU
Notes: Meter this wire while turning the key in the driver door key cylinder.

The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm orange - pin 25 at ETACS ECU
Notes: Meter this wire while turning the key in the driver door key cylinder.

The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock blue/red - pin 27 at ETACS ECU
Notes: Meter this wire while turning the key in the hatch/trunk key cylinder.

The ETACS ECU is attached to the back of the fuse box.
Tachometer white or black/white ac engine speed detection connector
Notes: The engine speed detection connector is a single pin connector in the fuse/relay box under the hood.

Can also go to one of the ignition coils or the distributor assembly and use the black/blue or white/green wire.
Wait to start N/A
Brake Wire green/orange + brake pedal switch
Parking Brake yellow/green - parking brake switch
Horn Trigger lt. green/black - pin 44 at ETACS ECU
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models.

Good luck.

I assume you are asking where it is safe to jack the vehicle with the factory provided jack. These locations are in front of both rear wheels there are jacking points you can see because they look like re-enforced parts of the body. The same points are behind the front wheels and will look the same. If you are looking for where the jack should be located in your car it should be in the trunk under the spare tire.

Fuel pump cut out switch. One of the back quarter panels(ford likes the left). Same kind of place the jack hides in most minivans. Typically little black box with little red button.

Probably sorted by now but in case anyone gets the same problem. Check all the red fuses in the main fuse box, not just the one the handbook says it should be. The main fuse box is behind the glove box...push in the sides and the gb will drop down....the fuse box is facing you.

Is the key you are using green? If so, it is the Valet Key and it will only lock the door - it will not work on the glove box or the trunk.

These cars have struts inside the springs. When the struts fail they start to make a noise that sounds like your problem. Also the strut mounts will make a terrible racket. Have these checked and replaced if needed. Hope this helps. Good luck.

Hi, does the alarm shut off when you unlock the passenger door?
If it does not I will give you a test that you can do.
1. disconnect the harness anti-theft control module. (loctaion depend were you live USA next to fuse panel Canadian models above the glove box.) Check the continuity between Light Green/Black wire and Black wire of the anti-theft control module.
2. Continuity should not be there with the door lock in, lock or neutral position. With the door lock in-between lock and neutral position (any door) continuity should be present.
3. If continuity is as specified replace the anti-theft control module. If continuity is not as specified, check operation of the door lock switches.I will add that test at bottom.
4. If the door lock switches are ok check the continuity og LIGHT/BLACK wires between anti-theft control module and door lock switches. Check Continuity of BLACK wire between door lock switches and ground. Continuity should be present if Continuity is not present repair harness or connectors.
5. If Continuity is present, check continuity LIGHT GREEN and BLACK wire of anti-theft control module. Continuity should not be present with trunk lock in lock or neutral position. With trunk lock in-between lock and neutral position, Continuity should be present.
6. If Continuity is as specified replace anti-theft control module. If Continuity is not as specified, check operation of truck lock switches. If necessary replace trunk lock switch.
7. If trunk lock switch is ok, check Continuity og LIGHT GREEN wire between anti-theft control module and trunk lock switch. Check Continuity of BLACK wire between trunk lock switch and ground. Continuity should be present. If Continuity is not present repair harness or connectors.

DOOR LOCK SWITCHES
Disconnect 4-pin door lock switch connect (left and right front doors) With door lock in neutral, full lock or full unlock position, there should be no continuity between any terminal and BLACK wire terminal. Continuity should exist between LIGHT GREEN?WHITE wire and BLACK wire terminals with door lock in-between neutral and full lock position. Continuity should exist between LIGHT GREEN/BLACK wire and BLACK wire terminals with door lock in-between neutral and full unlock positions. If continuity is not as described, replaced door lock switch.

Hope this help its a place to start. let me know if you need anything else.

Cheers