These are not codes , they are warning lights , telling you the driver that a problem exist .
code says, traction control off,next code says ,service stabilitrak and the last code says...engine power reduced.
DTC'S - diagnostic trouble codes could be stored in the control modules that control these system's . The main problem is more then likely with the reduced engine power. This is because of a problem with the electronic throttle control system . This problem will turn off these other thing's , turning on their light's .
Throttle Actuator Control (TAC) System Description
All newer vehicles have this ! There are position sensors in the Gas pedal and on the throttle body on the engine , The computer uses a DC volt electric motor to make the vehicle go . The sensors wear over time , the motor can wear , wiring can break etc...
Reduced Engine Power Mode
When the ECM detects a condition with the TAC system, the ECM may enter a reduced engine power mode. Reduced engine power may cause one or more of the following conditions:
• Acceleration limiting--The ECM will continue to use the accelerator pedal for throttle control; however, the vehicle acceleration is limited.
• Limited throttle mode--The ECM will continue to use the accelerator pedal for throttle control; however, the maximum throttle opening is limited.
• Throttle default mode--The ECM will turn off the throttle actuator motor and the throttle will return to the spring loaded default position.
• Forced idle mode--The ECM will perform the following actions:
- Limit engine speed to idle by positioning the throttle position, or by controlling the fuel and spark if the throttle is turned off.
- Ignore the accelerator pedal input.
• Engine shutdown mode--The ECM will disable fuel and de-energize the throttle actuator.
© 2017 General Motors Corporation. All rights reserved
I work at a chevy dealer an can not believe the one you took it to can't find the problem . Where is this dealer ? I will have a long talk with my district rep.
Drive by Wire Function and diagnostics by Wells
SOURCE: Service Stabilitrak-Reduced Engine Power
the engine light is a generic fault indicator in your car to point out something is not quite right with the engine, having a loss of power as well is also known in some areas as Limp Mode or Safety Mode. it means the car is restricting the power it gives to ensure no damage it done to the engine.
the only certain way to find out what is wrong is to take it to a garage that has diagnostics equipment that can read the fault codes from the vechicles ECU (the fault codes will be the reason the light on the dash has come on as its reporting a fault somewhere)..
your mechanic should be able to tell you what is wrong with the engine from that and give you a more accurate cost at fixing it.
SOURCE: The "engine power is reduced" light comes on
po455 is Probable Cause[s]
1. Defective, loose or missing fuel cap
2. EVAP canister broke, hose cracked or not connected
3. Purge or vent solenoid defective
4 . Vacuum leak at engine po121 code po121 means Throttle Position Sensor/Switch A Circuit Range/Performance Problem . it is usually indicative of a faulty throttle position sensor or faulty wiring harness in the engine bay.
SOURCE: my 2007 have a stabilitrak on and service traction...
I would advise to take it to a shop you trust and let them scan your vehicle for trouble codes. From there they can give you an idea as to why these messages appeared. : )
SOURCE: traction control off, service traction control,
{: ) Your stabilitrak system may not work properly. The vehicle need to be scanned for trouble codes. In case you get a C0196 code, the recommendation is to reprogram the electronic brake control module. I hope that's the only cause.
SOURCE: Service Throttle Control
my 2007 chevy impala check engine light is on sayin reduced engine power but mine wont start whats tha problem
810 views
Usually answered in minutes!
×