You don't need a diagram to replace all the
brake lines on that vehicle
I had one for 18.5 years and did them
3 times because of rust.
The only problem is that there is a little box (or bank) by the driver sie wheel and I can't get the 3 lines that go to it out. They are so rusted they just break right off.
You are going to have to pull that brass BLOCK. With the rusted lines(inside and out) the rust has been forced to the prop(proportioing valve). These can be opened up and cleaned of rust and you will have a better chance of getting the hydraulic fittings out with a small pipe wrench or use a torch SPARINGLY ! you can buy a new prop valve for $50 bucks-just make SURE it's for disc-drum setup(yours?). Otherwise the internal valving will be different. You don't want the rear wheels locking up before the front discs!!-Derfly
×
743 views
Usually answered in minutes!
×