Hi Amviergever,
The map sensor is a small unit fitted onto the bulk head fire wall (The panel which separated the passenger compartment from the engine compartment)....Its fitted about one meter from the identification plate. The map sensor is fitted in place by a ten millimeter bolt....It has a thin rubber vacuum pipe fitted underneath (about six millimeter outside diameter) and the other end is attached to the surge tank (which is the cylindrical casting on top of the intake manifold. The mapping sensor also has a small electrical connector. Pull off the pipe, disconnect the electrical connection and remove the bolt....Fit new unit....Bolt plug and electrics....To delete fault code from the memory of the computer, remove the EFI fuse from the fuse holder for about ten fifteen minutes and then replace. That's it.
Regards Johngee10
600 views
Usually answered in minutes!
×